Table of Contents
Advertisement
Supe X11DPU-Z+ User's Manual
Installing an HFI Carrier Card for Host Fabric Interface (HFI)
Support as Needed (Available when an F Model CPU is Used)
Note: Two host fabric interface carrier card headers (JHFI1/JHFI2) are located on the
motherboard. JHFI1 is used for CPU1; JHFI2, for CPU2. If one F model CPU is used,
install it on CPU Socket#1 first. Following the steps below to enable HFI support for
CPU1. If needed, repeat the same steps to enable HFI support for CPU2. (For more
information on the JHFI1/JFHI2 headers, please refer to page 51.)
Installation Instructions
1. Locate CPU Socket#1 on the motherboard. Install an F model CPU on CPU Socket#1.
(For CPU2 HFI support, install an F model CPU on Socket#2.)
2. Locate the PCI-E slots the motherboard. Install a Host Fabric Interface (HFI) card on a
PCI-E slot supported by CPU1. (For CPU2 HFI support, install an HFI card on a PCI-E
slot supported by CPU2.)
3. Connect the HFI connector on the HFI cable to the onboard JHFI1 header as show
below (marked 3 below.) (Connect the HFI cable to JHFI2 for CPU2 HFI support.)
4. Connect the other end of the HFI cable to the connector (marked
shown below. (Marked 4 below.)
5. Connect the plug (marked 5) on one end of the Internal_Faceplate_to_the_Processor
(IFP) cable to the connector (marked
6. Connect the other end of IFP cable (marked 6) to the F model CPU installed in the CPU
as shown below. Repeat the same steps to enable HFI support for CPU2.
IFP Cable (Optional)
HFI Carrier
Card
4. Connect another end of
4
the HFI cable to the
connector (A)
of the HFI card.
HFI (Host Fabric
Interface) Sideband
Cable
B
) on the HFI card as shown below.
6. Connect the other end of
6
the IFP cable to the
F model CPU.
5
5. Connect one end of
the IFP cable to the
connector (B)
A
of the HFI card.
2
B
2. Install an HFI card to a PCI-E slot
3
34
) on the HFI card as
A
Install an F model CPU
on Socket#1 (and another
F model CPU on Socket#2 if needed.
Then repeat Step 1 to Step 6
for HFI support for CPU2.)
1
F Model
Processor
VGA
COM1
USB0/1(3.0)
3. Connect the HFI connector
LEDM1
on the HFI cable to the
IPMI_LAN
BMC
onboard JHFI1 header.
BIOS
JSDCARD1
BATTERY
JBT1
JRK1
BT1
PCH
SP1
I-SATA4~7
I-SATA0~3
JSD2
JSD1
JHFI2 Header
JS1
JS2
USB2(3.0)
(for CPU2)
JHFI2
NVME12
NVME13
LE2
GPU PWR2
BIOS
JL1
LICENSE
IPMI CODE
BAR CODE
GPU PWR1
X11DPU-Z+
REV:1.01
CPU2
FAN8
FAN6
FAN5
JHFI1 Header
(for CPU1)
PSU1
PSU2
JPW4
JNVI2C1
JHFI1
NVME11
JHFI1
JPW3
CPU1
Advertisement
Table of Contents
