Table of Contents
Advertisement
Super X11DPU User's Manual
Installing an HFI Carrier Card for Host Fabric Interface (HFI)
Support as Needed (Available when the F Model CPU is Used)
Note: Two host fabric interface carrier card headers (JHFI1/JHFI2) are located on
the motherboard. Install an HFI card on an appropriate PCI-E slot of your choice and
F model CPU(s) on CPU socket(s) to use this feature. (For more information on the
JHFI1/JHFI2 headers, please refer to page 51.)
Installation Instructions
1. Locate CPU socket(s) on the motherboard. Install the F model CPU(s) on this socket as
shown below (marked 1. below) if you have not done so.
2. Locate the PCI-E slots. Install an Host Fabric Interface (HFI) card on an appropriate
PCI-E slot of your choice as shown below (marked 2. below).
3. Connect the HFI connector(s) (marked
header(s) as show below (marked 3. below.)
4. Connect the other end of the HFI cable to the connector (marked
shown below. (marked 4. below.)
5. Connect the plug (marked 5. below) on one end of the Internal_Faceplate_to_the_
Processor (IFP) cable to the connector (marked
6. Connect the other end of IFP cable (marked 6. below) to the F model CPU installed in
the CPU socket as shown below.
4. Connect another end of
the HFI Y cable to the
connector (A)
of the HFI card.
6
HFI Carrier
Card
HFI (Host Fabric
Interface) Sideband
Y Cable
3. Connect the HFI connector(s) (C)
on the HFI Y cable to the
onboard JHFI header(s).
IFP Cable (Optional)
5. Connect one end of
the IFP cable to the
connector (B)
A
of the HFI card.
B
2. Install
an HFI card to
a PCI-E slot.
C
) on the HFI cable to the onboard JHFI
C
) on the HFI card as shown below.
B
6. Connect the other end of
the IFP cable to the
F model CPU.
F Model
Processor
JHFI2 Header
(for CPU2)
CPU2
JF1
34
) on the HFI card as
A
1. Install the F model CPU(s)
on CPU socket(s).
JHFI1 Header
(for CPU1)
JHFI1
BIOS
DESIGNED IN USA
X11DPU
LICENSE
JHFI2
REV:1.10
BAR CODE
IPMI CODE
CPU1
Advertisement
Table of Contents
