Supermicro X11DPU-Z+ User Manual page 12

Super X11DPU-Z+ User's Manual
Quick Reference Table
Jumper Description
JBT1 CMOS Clear
JPG1 VGA Enable
JPME1 Manufacture Mode Select (ME Mode Select)
JWD1 Watch Dog Timer Enable
Connector Description
BT1 (Battery) Onboard CMOS battery
COM1 Back panel COM port
FAN1-8 4-pin system/CPU cooling fan headers (FAN8: a 4-pin vertical fan header)
IPMI_LAN Dedicated IPMI_LAN port
JF1 Front Panel Control header
JHFI1/JHFI2 Host Fabric Interface (HFI) sideband connection headers used for the HFI carrier cards (Available
(*Notes below) when F model processors are installed; JHFI1: for CPU1, JHFI2: for CPU2) (See Notes below.)
I-SATA0-3, I-SATA4-7 SATA 3.0 connections 0-3, 4-7 supported by the Intel PCH
JIPMB1 4-pin BMC external I
JL1 Chassis intrusion header
NVMe SMBus (I
JNVI C1/JNVI C2 proprietary NVMe add-on card and cable are required for the NVME I
2 2
available for a Supermicro complete system only.)
JP2 Complex Programmable Logical Device (CPLD) header
JGPW2/JGPW4 GPU power connectors (JGPW4: GPU Power Connector1/JGPW2: GPU Power Connector2)
JPW1/JPW2 8-pin power supply connectors for backplane devices
JPW3/JPW4 8-pin power supply connectors
JRK1 Intel RAID Key header used for NVMe Solid State Devices (SSD)
JSD1/JSD2 Power connectors used for SATA DOM (Disk_on-Module) devices
JSDCARD1 Solid State Device (SSD) add-on card header
JTPM1 Trusted Platform Module (TPM)/Port 80 connector
NVME10/JNVME11 NVMe Connector1/NVMe Connector2 for CPU1
NVME12/JNVME13 NVMe Connector1/NVMe Connector2 for CPU2
PSU1/PSU2 Power supply unit 1/power supply unit 2 reserved for Supermicro system use
SP1 Internal speaker/buzzer
Notes: 1. For the HFI sideband carrier cards to function properly, please install a Host
Fabric Interface (HFI) card to an appropriate PCI-E slot of your choice, and install an
F model processor to the corresponding socket (JHFI1: for CPU1, JHFI2: for CPU2.
When one F model is used, be sure to install it on CPU Socket#1.) 2. Connect an HFI
cable from the HFI card to JHFI (HFI header) and connect an IFP cable from HFI card
to the processor. (See Pages 34 and 51 in Chapter 2 for more information.)
C header (for an IPMI-supported card)
2
C) headers used for PCI-E hot-plug SMBus clock & data connections (an SMCI-
2
12
Default Setting
Open (Normal) (See Chapter 2)
Pins 1-2 (Enabled)
Pins 1-2 (Normal)
Pins 1-2 (Reset to System)
C header. This feature is
2