Table of Contents
Advertisement
6.2 Connection Settings
This screen allows you to configure how the MAX208M2W Series connects to the
base stations on the WiMAX network.
Click WiMAX > Profile > Connection Settings to open this screen as shown
next.
Figure 23 Connection Settings Screen
This screen contains the following fields:
Table 13 Connection Settings
LABEL
Connection Option Settings
Auto
Reconnect
Auto
Connect
Mode
Enable
Handover
Enable Idle
Mode
MAX208M2W Series User's Guide
DESCRIPTION
Select the interval in seconds that the MAX208M2W Series waits after
getting disconnected from the base station before attempting to
reconnect.
Select the auto connect mode.
•
By channel power - Auto connects to the base station if the signal
strength of the channel is sufficient for the MAX208M2W Series.
•
By CINR - Auto connects to the base station if the signal-to-noise
ratio is sufficient for the MAX208M2W Series.
Select this to maintain connectivity while the MAX208M2W Series
switches its connection from one base station to another base station.
Select this to have the MAX208M2W Series enter the idle mode after it
has no traffic passing through for a pre-defined period. Make sure your
base station also supports this before selecting this.
Chapter 6 WiMAX
71
Advertisement
Table of Contents
