Table of Contents
Advertisement
Chapter 8 Security
8.2 IP Filter
Use this screen to block incoming connections from specific IP addresses.
Click Security > Firewall > IP Filter to open this screen as shown next.
Figure 58 IP Filter Screen
This screen contains the following fields:
Table 45 IP Filter
LABEL
Active
Source IP
Source Port
Destination IP
Destination Port This displays the destination port number for the IP filter rule.
Protocol
Delete
Add
OK
128
DESCRIPTION
Indicates whether the current IP filter is active or not.
This displays the source IP address for the IP filter rule.
Click Add to create a new, empty rule, then enter the incoming IP
address for the MAX208M2W Series to block.
If you want to delete this rule, click the Delete icon.
This displays the source port number for the IP filter rule.
Click Add to create a new, empty rule, then enter the incoming port
number for the MAX208M2W Series to block.
If you want to delete this rule, click the Delete icon.
This displays the destination IP address for the IP filter rule.
Click Add to create a new, empty rule, then enter the outgoing IP
address for the MAX208M2W Series to block.
If you want to delete this rule, click the Delete icon.
Click Add to create a new, empty rule, then enter the outgoing port
number for the MAX208M2W Series to block.
If you want to delete this rule, click the Delete icon.
This displays the protocol blocked by the IP filter rule.
Click Add to create a new, empty rule, then select the protocol type for
the MAX208M2W Series to block.
If you want to delete this rule, click the Delete icon.
Click this to delete a specified rule.
Click this to add a new filter rule.
Click this to save any changes made to the list.
MAX208M2W Series User's Guide
Advertisement
Table of Contents
