Siemens SINAMICS G130 Operating Instructions Manual page 16

Setting parameters with the BOP20
4.1 BOP20 overview
Table 4- 2 Keys
Key Name
ON
OFF
Functions
Parameters
Raise
Lower
14
Switches on the drives for which the command "ON/OFF1" is to be issued from the BOP.
Binector output r0019.0 is set using this key.
Switches off the drives for which the commands "ON/OFF1", "OFF2", and "OFF3" are to be
issued from the BOP.
The binector outputs r0019.0, .1 and .2 are reset simultaneously when this key is pressed.
After the key has been released, binector outputs r0019.0, .1 and .2 are again set to a "1"
signal.
Note:
The effectiveness of these keys can be defined by parameterizing the BICO (e.g. these
keys can be used to control all of the existing drives simultaneously).
The significance of this key depends on the current display.
Note:
The effectiveness of this key for acknowledging faults can be defined by parameterizing the
BiCo accordingly.
The significance of this key depends on the current display.
If this key is pressed for 3 s, the "Copy RAM to ROM" function is executed. The "S"
displayed on the BOP disappears.
The keys depend on the current display and are used to either raise or lower values.
Meaning
Basic Operator Panel 20 (BOP20)
Operating Instructions, 03/2013, A5E00809375A