3Com CoreBuilder 5000 User Manual page 49

This example monitors Fast_Ethernet_1 every 10 seconds:
CB5000> monitor 00:10 repeater fast_ether_1
Repeater Statistics for FAST_ETHER_1
---------------------------------------------------------
----------------------------------------------------------
Transmit Collisions
Readable Frames
Readable Octets
Upper 32 Readable Octets 142
Runts
FCS Errors
Late Events
Short Events
Frame Too Long
Very Long Events
Alignment Errors
Collisions
Data Rate Mismatches
Auto Partition Count
Isolates
Symbol Errors
Last Source Address
Display will refresh every 10 seconds.
Press CTRL-C to exit.
In the previous example, the Upper 32 Readable Octets display 140.
(The actual count of octets is 142 x (times) 2
100BASE-TX Workgroup FastModule Version v1.10 and DMM Version
v5.0 support three new 100MB repeater statistics (Upper 32 Readable
Octets, number of Isolates, and Symbol Errors) using the SHOW
COUNTER command and the MONITOR command. 100BASE-TX
Workgroup FastModule Version v1.10 works with DMM Version v4.10.
However, DMM Version v5.0 is required to display the three new
repeater statistic entries.
If you are using DMM Version v5.0, you must use 100BASE-TX
Workgroup FastModule Version v1.10 to properly display any statistics.
Transmit collisions only display on a network level (not port or module
level). Transmit collisions statistics are not supported by this module.
Status on the module has a periodic rate of gathering statistics and
updating approximately every second.
Gathering Repeater Statistics
Cumulative Last Time Interval
0 0
51857 28255
53308996 29046140
1
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
N/A 08-01-20-21-3d-52
32
.)
4-9