Operating The Telephone On A Pabx - Gigaset C530 IP Manual

Gigaset C530 IP / LUG - USA en / A31008-XXXXX-XXXX-X-XX / PABX.fm / 25.03.2015

Operating the telephone on a PABX

Operating the telephone on a PABX
The following settings are only necessary if your PABX requires them; see the PABX user guide.
Dialling modes and flash time
Changing the dialling mode
Ï
You can choose between tone dialling (Tone) and pulse dialling (Pulse).
v
¤
¤ q Select dialling mode
Regardless of the setting, the phone automatically switches to tone dialling (DTMF) after dialling
or during a call, e.g. for controlling an answer machine remotely.
Setting flash time (fixed line network)
By default, your phone is set for operation on the main connection (flash time 250 ms). For
operation on a PABX, you may have to change this value. Please refer to the user guide of your
PABX.
v Ï
¤
Possible values: 80 ms, 100 ms, 120 ms, 180 ms, 250 ms, 300 ms, 400 ms, 600 ms, 800 ms.
Saving an access code (outside line code)
If you must enter an access code in front of the phone number for external calls using your PABX
(e.g. "0"), you can enter an access code for dialling via the fixed line network and for dialling via
VoIP.
v Ï
¤
Fixed line
network:
VoIP:
¤
For:
r
Call Lists: The access code is prefixed only to numbers dialled from one of the following
lists: accepted calls list, missed calls list.
r
All calls: The access code is prefixed to all numbers dialled.
r
Off: The access code for the fixed line network is deactivated. It is not prefixed to any
phone number.
¤
Save
Note
The access code never prefixes any emergency numbers.
90
¤ ¤
q Telephony
OK
¤
Select (Ø= selected).
¤ ¤ ¤
OK Telephony OK
¤ ¤ ¤
q Telephony
OK
Access external line with:
Access external line with:
¤ ¤
q Dialling Mode
OK
¤ ¤ q Select flash time
Recall
¤
q Access Code
OK
¤
Enter or change access code, max. 3 digits.
¤
Enter or change access code, max. 4 digits.
¤
OK
¤
Select (Ø =selected).
¤
OK