Page 1
C530 Congratulations By purchasing a Gigaset, you have chosen a brand that is fully committed to sustainability. This product’s packaging is eco-friendly! To learn more, visit www.gigaset.com.
Do not charge the handset in charging unit or base station while the headset is connected. If you give your Gigaset to a third party, make sure you also give them the user guide. Remove faulty devices from use or have them repaired by our Service team, as these could interfere with other wireless services.
This brief introduction with installation wizard for your telephone, license texts, warranty agreement and links to the detailed user guide and important websites. In the event of any firmware updates for your base, the user guide is also updated if necessary and available to download online from www.gigaset.com. en fr es...
Page 5
Handset display and keys Handset display and keys Display in idle status Status bar Icons display current settings and operating status of the phone Display keys Message key Access to the calls and message lists; Flashing: new message or new call End call key, On/off key End call;...
To connect the base to the internet, connect the base to the router (connection via router and modem or via router with integrated modem) PC in LAN (optional) - for further configuration of the Gigaset C530 IP base en fr es...
Preparing the handset Preparing the handset Insert the batteries supplied and close the battery cover ¤ ¤ Insert the batteries with Insert the battery cover To re-open the battery the polarity in the right from the top cover: ¤ ¤ direction (for correct +/- Press the cover until it Grip the notch on the...
Connecting the base Connecting the base Connect the phone cable and power cable to the base ¤ Insert the (flat) telephone cable into the lower connection socket at the rear of the base ¤ Insert the power cable from the power adapter into the upper connection socket at the rear of the base...
Page 9
(paging key). Data protection information: For more information on the data saved in relation to the Gigaset.net service, please go to www.gigaset.net/privacy-policy.
Open the web browser on your PC. ¤ Enter the URL www.gigaset-config.com into the address field of your web browser and press the return key. You will be connected to the web configurator of your base. For registration using the web configurator, you will need the system PIN of the telephone (factory setting: 0000).
Configuring VoIP connections Start configuration When your handset is sufficiently charged (approx. 20 minutes after placing it in the charging cradle), the Message key flashes on the handset. ¤ Press the Message key on the handset. If "New firmware available" is shown on the display, there is a firmware update available for §Yes§...
Page 12
Configuring VoIP connections A list of all possible IP connections will be shown in the display (IP 1 to IP 6). VoIP connections that ³ Select IP Account are already configured are marked with ¤ ´ IP 1 If required, press down on the control key ´...
Page 13
Configuring VoIP connections Enter the auto-configuration code ¤ Enter the auto-configuration code using the keypad (max. 32 characters). ¤ IP Wizard §OK§ Press the display key Activation code for All data required for VoIP telephony is downloaded directly from the Internet onto your autoconfiguration: telephone.
Page 14
¤ Change the configuration and assignment of the incoming and outgoing connection using the web configurator. For further information, please refer to the detailed user guide online at www.gigaset.com/C530ip. Enter VoIP account data ¤ To switch between upper/lower case and digit entry: Press the key (multiple times if required).
Page 15
Fixed Line: 4560123 to change the incoming connection selected. IP 1: 12345602 ¤ §OK§ Press the display key if you do not Gigaset.net: 12345#9 want to change the setting. The following steps are skipped. Continue Change from step e. en fr es...
Page 16
Press right on the control key to set to No. Receive calls for IP 1: < Yes > Receive calls for Gigaset.net: Back Save ¤ To switch to the next connection: Press down on the control key . Set INT 1 to Yes or No as described above.
Page 17
Assigning an incoming/outgoing connection The handset displays the outgoing connection that is currently set for the Send Connections handset: Ð Fixed Line. ¤ To retain setting: Press the display key INT1 §OK§ . The following step is skipped. ¤ sends calls with To change the setting: Press the display §Change§...
You can configure a further five VoIP connections (VoIP numbers). In the detailed user guide for your telephone (online at www.gigaset.com/C530ip, you will find comprehensive information on setting up, configuring new connections and operating the telephone, as well as possible solutions to frequent questions and problems.
Page 19
** Data protection information Your nickname is saved on a central Gigaset server and appears in the Gigaset.net phonebook. You can be called by other users of the Gigaset.net service under this nickname. By entering your information, you agree for this data to be saved.
Making calls Making calls Making calls ¤ Dial the number using the digit keys on your handset. Please note that you must also dial the area code for VoIP calls, even for local calls (depending on your provider). ¤ Press the Answer call key Fixed outgoing connections assigned: The number is dialled using this outgoing connection.
Environment Our environmental statement We at Gigaset Communications GmbH are aware of our social responsibility. That is why we actively take steps to create a better world. In all areas of our business – from product planning and production to sales and waste of disposal – following our environmental conscience in eve- rything we do is of utmost importance to us.
Environment Care Wipe the device with a slightly moistened cloth or an antistatic cloth. Do not use solvents or microfibre cloths. Never use a dry cloth; this can cause static. In rare cases, contact with chemical substances can cause changes to the device’s exterior. Due to the wide variety of chemical products available on the market, it was not possible to test all substances.
Environment Industry Canada Certification Operation is subject to the following two conditions (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. NOTICE: The Industry Canada label identifies certified equipment. This certification means that the equipment meets certain telecommunications network, protective, operational and safety requirements as prescribed in the appropriate Terminal Equipment Technical Requirements document(s).
FCC / ACTA Information FCC / ACTA Information Warning: Changes or modifications to this unit not expressly approved by Gigaset Communications USA LLC could void the FCC authority to operate the equipment. This includes the addition of any external antenna device.
Page 25
FCC / ACTA Information This telephone system equipment has been tested and found to comply with the limits for Class B digital device, pursuant to Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
Page 26
FCC / ACTA Information Safety precautions Before using your telephone equipment, basic safety instructions should always be followed to reduce the risk of fire, electric shock and injury to persons. 1. Read and understand all instructions. 2. Follow all warnings and instructions marked on the product. 3.
FCC / ACTA Information 14. Do not use the telephone to report a gas leak in the vicinity of the leak. 15. Emergency/911 numbers may not be dialed if the keypad is locked. 16. Minimum No. 26 AWG telecommunication line cord must be used with this phone. BATTERY SAFETY PRECAUTIONS To reduce the risk of fire, injury or electric shock, and to properly dispose of batteries, please read and understand the following instructions.
Communications USA LLC or Gigaset Communications Canada Inc. (collectively "Gigaset NAM"). Gigaset NAM warrants to you that at the date of purchase, the Product is free of defects in workmanship and materials and the software included in the Product will perform in substantial compliance to its program specifications.
AUTHORIZED BY GIGASET NAM MAY VOID WARRANTY. 4. WARRANTY CLAIM PROCEDURE All warranty claims must be made by notifying Gigaset NAM prior to the expiration of the warranty period. Gigaset NAM's obligation to provide warranty support shall not extend past...
In no event shall Gigaset NAM's liability exceed the cost of repairing or replacing defective Products as provided herein, and any such liabilities will terminate upon expiration of the warranty period.
United Nations Convention on Contracts for the International Sale of Goods. If you want to learn more about Gigaset Service or for Support on your Gigaset phone, visit our web site at http://www.gigaset.com or please call 1-866 247-8758 tollfree.
The liability of Gigaset Communications GmbH remains unaffected by this. Licence and copyright information Your Gigaset unit includes Open Source software which is subject to the GNU General Public License (GPL) or the GNU Library/Lesser General Public License (LGPL). The corresponding licence conditions can be found below in their original version.
Page 33
Open Source Software Licence texts GNU LESSER GENERAL PUBLIC LICENSE Version 2.1, February 1999 Copyright (C) 1991, 1999 Free Software Foundation, Inc. 51 Franklin Street, Fifth Floor, Boston, MA 02110-1301 USA Everyone is permitted to copy and distribute verbatim copies of this license document, but changing it is not allowed. [This is the first released version of the Lesser GPL.
Page 34
Open Source Software TERMS AND CONDITIONS FOR COPYING, DISTRIBUTION AND MODIFICATION 0. This License Agreement applies to any software library or other program which contains a notice placed by the cop- yright holder or other authorized party saying it may be distributed under the terms of this Lesser General Public License (also called "this License").
Page 35
Open Source Software 5. A program that contains no derivative of any portion of the Library, but is designed to work with the Library by being compiled or linked with it, is called a "work that uses the Library". Such a work, in isolation, is not a derivative work of the Library, and therefore falls outside the scope of this License.
Page 36
Open Source Software acceptance of this License to do so, and all its terms and conditions for copying, distributing or modifying the Library or works based on it. 10. Each time you redistribute the Library (or any work based on the Library), the recipient automatically receives a license from the original licensor to copy, distribute, link with or modify the Library subject to these terms and condi- tions.
Page 37
Open Source Software This library is free software; you can redistribute it and/or modify it under the terms of the GNU Lesser General Public License as published by the Free Software Foundation; either version 2.1 of the License, or (at your option) any later version.
Need help?
Do you have a question about the C530 IP and is the answer not in the manual?
Questions and answers