Mechanical Interconnection Of Pqfm Cubicles - ABB PQFM Instruction Manual

Repeat steps 3 to 5 for
the bottom Mounting
Bracket.
Step 1: Slide the PQF-Manager (a) perpendicularly to the Capacitor Bank Cubicle (b).
Step 2: Rotate the PQF-Manager to insert it into the Capacitor Bank Cubicle.
Note: cut out dimensions are 138 x 138 mm.
Step 3: Insert the Mounting Bracket (c) in the corresponding Fixation Holes (d) of the
PQF-Manager.
Step 4: Pull the Mounting Bracket backwards.
Step 5: Turn the Screw (e) into the Mounting Bracket and tighten until the PQF-Manager
is secured in place.
Once the PQF-Manager has been installed, it has to be connected electrically (see
6.2).
5.6

Mechanical interconnection of PQFM cubicles

This section explains how to mechanically interconnect PQFM units (master-master,
master-slave or slave-slave).
interconnect two PQFM units.
Step 2
(b)
(c) Step 4
Step 3
(d)
Step 5 (e)
Figure 21: Mechanical installation of the PQF-Manager
Figure 22
Manual Power Quality Filter PQFM ç Mechanical design and installation 39
(a)
Step 1
outlines the steps to undertake to mechanically
Section