Table of Contents
Advertisement
The Player Does Not Power On
Ÿ
The AC Power cord may be loose or not plugged in. Make sure the power cord is secure in the AC socket.
Ÿ
The Battery Pack may be unattached. Make sure the Battery Pack is attached to the unit firmly.
Ÿ
The Power of the Battery Pack may be exhausted. Recharge the Battery Pack.
Ÿ
The unit may be in Standby Mode. Turn the unit on with the remote POWER button or PLAY/PAUSE/ENTER Button on
the player.
Ÿ
There must be a pause between powering the unit down and back on of a few seconds.
Ÿ
Remove Battery Pack or AC Adapter to RESET the player.
A Specific Disc Does Not Play
Ÿ The disc may be dirty. Try cleaning the disc.
Ÿ
Make sure the disc is not in upside-down
Ÿ
The region code of the disc may not match that of the player. In this case, the disc cannot be used.
Ÿ
Disc may not be industry standard.
The Remote Control Does Not Function
Ÿ
Make sure you re aiming the remote directly at the player s remote sensor, located in the front display.
'
Ÿ
Make sure there are no obstacles between the remote and the player.
Ÿ
The batteries may be drained. Try changing the batteries in the remote.
Ÿ
You could be using the remote too far away. Try within 4 meters of the player.
Ÿ
Relocate the player to test if these is interference.
Subtitles not shown
Ÿ
Press Remote Control Subtitle button to turn it on.
Ÿ
Subtitles display only recorded on DVDs.
The Picture Appears Stretched or Squeezed
Ÿ
The LCD Mode you are in may be wrong for the movie your re watching. Try changing the LCD setting to suit the movie s
aspect ratio (Standard or Widescreen).
Ÿ
The Video Aspect Ratio may be set wrong for your Television type.
Ÿ
Enter the Setup Menu and select the Video Menu. Try changing the ASPECT setting to 4:3 PS (Pan&Scan) if you are
using a standard TV, or 16:9 WS if your TV is a Wide-Screen type.
No Sound from TV or Speakers
Ÿ
Once you close the unit s Disc Cover, the unit is still running, but No Sound comes out.
Ÿ
Disc is Dirty or Damaged. Clean the Disc or change to another one.
Ÿ
Volume Control is set to Minimum. Raise up the Volume.
Ÿ
Headphones are connected. Pull out the Headphones.
Ÿ
If you are using a Digital Receiver, check the Dolby/DTS setting in the player s Setup Menu .
Ÿ
Make sure the audio cables connecting the DVD player to your TV or receiver are secure.
Ÿ
The movie is paused. There is no sound during Pause or Search modes.
No Image on the Built-in Screen
Ÿ
Power isn t on. Turn on the Power.
'
Ÿ
Video Mode setting may be in Video output to external monitor mode. Press VIDEO MODE Button to change to Normal
player operation.
Ÿ
Make sure the player is not in LCD Off Mode.
Distorted Picture when Connected to a VCR
Ÿ This Player is built with Macrovision copy-protection. This will distort the signal when used with VCRs. Connect the player
directly to the TV.
TROUBLESHOOTING
'
'
'
'
37
'
Advertisement
Table of Contents
