Powering On And Off The Unit; Inserting A Disc - Denver MT-703 User Manual

Powering on and off the unit

Only after all connections are complete, connect the power
cord and power on the unit.
1
To power on the unit, press the POWER key on the
remote control or the ON key on the front panel of the
unit. The unit is now ready to use.
POWER
LCD
TITLE MENU
ANGLE
BOOKMARK
2
To power off the unit, press the POWER key on the
remote control or the OFF key on the front panel of the
unit. The unit is now ready to use.
POWER LCD
TITLE MENU
BOOKMARK ANGLE
Notes on power states
There are 3 power states for this unit:
Ÿ
OFF - The main power switch is turned off. The unit draws
no power and cannot be turned on by the remote control.
Ÿ
STANDBY - The main power switch has been turned ON,
but the unit has not been taken out of standby by pressing
either the STANDBY key on the remote control or the ON /
STANDBY button on the front panel. The unit draws a
slight amount of power to enable the remote control
receiving circuit.
Ÿ
ON - The main power switch has been turned ON, and
either the STANDBY button on the remote control
ON / STANDBY button on the front panel has been
pressed. The unit is ready to use.

Inserting a disc

1
Press the PUSH OPEN button on the front panel to open
the disc door.
PORTABLE DVD PLAYER
GETTING STARTED
GETTING STARTED
SETUP
MONITOR
GOTO DISPLAY
SUBTITLE PROGRAM
SETUP MONITOR
GOTO DISPLAY
SUBTITLE PROGRAM
2
Insert the disc, being careful not to touch the playing
surface. Hold the disc by the sides and with your fore
finger through the hold in the middle and insert gently
into the tray.
3
Close the disc tray door and the unit will automatically
start playback of the disc.
or the
19
Labeling Side
Surface