Installing The Battery; Important Notes About The Battery; Operation Of Remote Control - Denver MT-703 User Manual

Installing the Battery

If the remote control only operates when you get closer to the DVD Player, it may indicate that the battery is weak. Please
replace the battery (Lithium battery) simultaneously with a new battery of the same type
positive (+) side is facing upwards when the remote is held as shown below.
1. Please become familiar with your remote
controller s battery holder parts below. '
Release Clip
3. Use you thumbnail to squeeze the release clip
inward, while at the same time,pull the Handle out
with your index fingernai.

Important Notes about the Battery

Ÿ
If the unit will not be used for an extended length of time, it s wise to remove the battery before storage.
Ÿ
The life of the battery depends on the amount of usage. With typical usage, a battery life of approximately 6 months can
be expected.
GETTING STARTED
2. Grasp the remote with the underside facing upward. Notice the release
clip to the left and handle to the right. To remove the battery holder, place
pressure on the release clip towards the center of the remote,while pulling
the handle out towards you, as the arrows show.
Handle
(CR 2025)
4. Insert new battery into the holder. Make sure that
positive(+) side is facing upwards. Return the
battery holder back into the remote.
'

Operation of Remote Control

When using the Remote control, please aim at
the device's remote control sensor, located on the
front of DVD Player. A 30 degree angle is
recommended for best operation.
° °
30
30
7
. Please note the
Remote Control
Bottom
Remote Control
Bottom
Quick Tips
Ÿ
Make sure no objects
are between the remote
and the player.
Ÿ
Similar remote controls
could interfere with the
function of the player.
Ÿ
Make sure not to store
the remote upside
down or with any
objects pressing on the
buttons - this could
drain the battery.