Removing The Battery Pack - Denver MT-703 User Manual

Preparing the battery pack for use
The DVD player comes complete with a battery pack to allow
playback without any AC power source.
1
Before using the battery pack the first time, you must
first charge it. Connect the battery pack to the AC
adapter as shown below. The LED will turn green
when fully charged.

Removing the battery pack

It will be necessary to remove the battery pack from your unit
from time to time.
1 1
Turn the DVD player upside down as shown below. To
remove the battery door, press the tab to disengage the
lock. Slide the battery door downward.
BATTERY PACK
2
Press the Function key on the front panel or the
Display key on the remote control to check the
battery pack status. Use the table below as a guide
to the current battery pack status. If the front panel
power indicator is blinking, the battery pack has less
than 10 minutes of charge remaining.
!
!
Ÿ
Recharge your battery pack when the battery status is
less than 25%.
Ÿ
Unnecessary charging will reduce the battery pack
service lifetime.
Ÿ
When the battery pack is being charged, the LED will
glow red.
Ÿ
After successfully charging the battery pack, the LED will
glow green.
Ÿ
The time to charge the battery pack is normally 3 to 4
hours. Do not charge for more than 8 hours.
Detaching the battery pack
Detach the battery pack from the DVD player if you will be
storing the unit for an extended period of time. The unit will
continue to consume power while the battery pack is attached
and turned off. Over discharge of the battery pack will lead to
reduced service life time. Ensure the unit is turned off before
detaching the battery pack.
1
2
Gently slide the battery pack towards the back of the
unit. Lift the battery pack from your unit. Replace
the battery terminal protector back onto the unit.
12
Important
Slide the latch toward the front of the unit. Hold the
tab in this position.