Table of Contents
Advertisement
DTS
RAW
Default setting:
SPDIF ( Sony / Phillips Digital InterFace ) refers to the digital
audio format used by most consumer electronics equipment. If
you are using the Stereo Audio Output, change this setting to
PCM
. Generally, the
RAW
capable of Dolby Digital 5.1 or DTS 5.1 channel decoding,
while the
PCM
setting is reserved for two channel equipment.
Off
Select
if you are using stereo audio outputs.
MPEG
Default setting:
PCM
If you are using the Stereo Audio Output, leave this setting at
PCM
RAW
. Generally, the
capable of Dolby Digital 5.1 or DTS 5.1 channel decoding,
while the
PCM
setting is reserved for two channel equipment.
Off
Select
if you are using stereo audio outputs.
PCM CHANNEL
Default setting:
SPDIF L / R
When connecting the unit to a receiver capable of supporting a
six speaker system, use this option to configure each pair of
SPDIF L/R
speakers.
is used for configuration of the left and
right front speakers.
SPDIF LS/LR
for the left and right satellite speakers.
subwoofer )
is for the center speaker and subwoofer.
LPCM Out
48K
Default setting:
Select from
48K
or
96K
for this selection.
DUAL MONO
Default setting:
STEREO
These settings are generally for CDs or VCDs that offer only
Mono audio tracks. In this case, the
function as normal stereo, while the
will send the mono output to only one speaker.
will send the same mono output to both speakers.
DYNAMIC
Default setting:
Off
'Dynamic Range Compression' makes watching a movie at
low volumes more enjoyable by boosting the quieter sounds
while suppressing the louder sounds. This reduction in the
difference between the low and high audio levels is known as
"compression". You can adjust the level of this compression
from
OFF
to
FULL
, using the UP/DOWN ARROW buttons.
SOUND SETUP
. . . .
Sound Setup Page
Sound Preset
Bass Boost
Super Bass
Treble Boost
Go to sound setup page
THE DVD PLAYER SETUP MENU
setting is used with receivers
setting is used with receivers
designates configuration
SPDIF C/LFE ( or
STEREO
option will
L-MONO
R-MONO
and
MIX-MONO
. .. .
None
None
Off
Rock
Off
Pop
Off
Live
Dance
Techno
Classic
Soft
SOUND PRESET
NONE
Default setting:
Choose from a variety of equalization presets that simulate
popular environments for listening to music.
BASS BOOST
Off
Default setting:
ON
When set to
, the low frequency range is increased.
SUPER BASS
Default setting:
Off
ON
When set to
, the low frequency range is increased.
TREBLE BOOST
Default setting:
Off
ON
When set to
, the high frequency range is increased.
HDCD SETUP
.. .
.
Sample Rate
Set the sample rate
HDCD
Default setting:
Off
Choose from two different Khz settings for HDCD.
The PASSWORD SETUP PAGE
. .
. .
Password
Change Psw
Parental
Go To Security Setup Page
PASSWORD
Default setting: Off
Here is where you can set an additional password to the default
factory password. The procedures to change an existing
password or enter a new password are the same - you must enter
the OLD PASSWORD, then key in your new password twice to
confirm. If you are entering a new password, or replacing a
password you have forgotten, use the factory default password
of 1379 as the OLD PASSWORD. If you are changing a
previously entered password, you may enter that value as the old
password.
34
. .
HDCD Setup Page
Off
Off
44.1K
88.2K
. .
. .
Security Setup Page
Video Setup Page
On
Off
Advertisement
Table of Contents
