External Battery Pack; Preparing The Battery Pack For Use; Using The Battery Pack; Detaching The Battery Pack - Denver MT-703 User Manual

Table of Contents

Advertisement

Preparing the battery pack for use

The DVD player comes complete with a battery pack to allow
playback without any AC power source.
1
Before using the battery pack the first time, you must
first charge it. Connect the battery pack to the AC
adapter as shown below. The LED will turn green
when fully charged.
BA TT ER Y
PA CK
LE D

Using the battery pack

Attaching the battery pack to the DVD player is an easy few
steps.
1
Turn the unit upside down. Remove the battery
terminal protector ( replace this protector when
battery pack is not used). Align the battery pack s
guides to the unit s slots.
'
2
To secure the battery pack to the unit, ensure the
battery pack locks onto the unit. To lock the battery
pack into place, gently slide the battery pack toward
the front on the unit until there is an audible click.

EXTERNAL BATTERY PACK

DC IN 9V
'
DVD PLAYER
SLOTS
2
Press the Function key on the front panel or the
Display key on the remote control to check the
battery pack status. Use the table below as a guide
to the current battery pack status. If the front panel
power indicator is blinking, the battery pack has less
than 10 minutes of charge remaining.
100%
70%
50%
20%
!
!
Important
Ÿ
Recharge your battery pack when the battery status is
less than 25%.
Ÿ
Unnecessary charging will reduce the battery pack
service lifetime.
Ÿ
When the battery pack is being charged, the LED will
glow red.
Ÿ
After successfully charging the battery pack, the LED will
glow green.
Ÿ
The time to charge the battery pack is normally 3 to 4
hours. Do not charge for more than 8 hours.

Detaching the battery pack

Detach the battery pack from the DVD player if you will be
storing the unit for an extended period of time. The unit will
continue to consume power while the battery pack is attached
and turned off. Over discharge of the battery pack will lead to
reduced service life time. Ensure the unit is turned off before
detaching the battery pack.
1
1
Slide the latch toward the front of the unit. Hold the
tab in this position.
2
Gently slide the battery pack towards the back of the
unit. Lift the battery pack from your unit. Replace
the battery terminal protector back onto the unit.
11
Fully Charged
Three Fourth Charge Reminding
Remaining Charge is getting low
Almost out of Power
2

Advertisement

Table of Contents
loading

Table of Contents