Closing; The Master Console - Bosch BIS 2.3 Installation Manual

BIS 2.3 - Access Engine
Special delays such as the start delay, the restart delay, idle
times before terminating a process, etc. are specified by the
system parameters that are saved in the registry.
The master process uses the time control properties that are
explained in the table above to start the server processes.
These include batch programs for tasks that only need to be
performed periodically. This reduces the number of processes
that are running continuously.
If the core system is to be halted, the master process uses "exit
numbers" to determine the process sequence in which the
system will be shut down. The processes with the highest exit
numbers are stopped first. Processes with a low exit number
are only stopped once the processes with the higher exit
numbers have been terminated. If a process does not terminate
correctly, it is closed after a short idle time.
NOTICE!
Interactive processes can have a high exit number, the core
i
areas, however, should have low exit numbers. The loggifier, for
example, which is a central process of the system, should be
stopped last, as other processes may require this service in
order to shut down properly.
10.1.2

Closing

The closing and shutdown of the access control system is
handled exclusively using the BIS System Manager and should
not be forced by terminating the service.
10.1.3

The master console

The master console can be called up using the context menu
(right mouse button) of the Systray icon
. It is possible to open either only this console window or to
open the control window for all DMS processes by selecting the
"Process Control" option - see following section.
Bosch Sicherheitssysteme GmbH
DMS - Data Management System | en
Installation manual F.01U.028.713 | V 2.3.0.1 | 2009.11
81