Bosch B Series Instructions

Bosch B/G Series Alarm System Instructions
Arming and Disarming Your System
To arm (turn on) your system:
The keypad must say "READY TO ARM." If this message appears on the keypad, enter
your four-digit code on the keypad and then push the "ENT" (enter) key.
Your arming/disarming codes are: __________ ___________ ___________
___________ ___________ ___________ ___________ ___________
The keypad will then show "ALL SECURE, EXIT NOW." You will hear the keypad
beep. You have __________ seconds to exit. Open the delay door and exit.
Your delay door is located at: ____________________.
Please note: All doors must be closed when arming the system.
To disarm (turn off) your system:
When entering the building, enter through the delay door ONLY.
Upon opening the door you will hear a beeping sound, this is the pre-alarm. You have
_________ seconds in which to enter the four-digit code to turn the system off. Enter
your four-digit code and press the ENT (enter) button.
If alarm occurs:
Put in your Code + Enter. This will silence the alarm. Check the zones that went into
alarm, which is displayed by the keypad. Once you have checked them, go back to the
keypad and push Enter + Your Code + Enter. This will clear the system out so you may
continue to arm and disarm.