Creating Additional Configurations - Bosch BIS 2.3 Installation Manual

BIS 2.3 - Access Engine
1.
2.
NOTICE!
i
If you performed this setup using the user BIS then see also the
instructions in Section 4.5 Setting up BIS user, Page 31.
4.2.2

Creating additional configurations

To create additional configurations proceed as follows:
1.
2.
3.
NOTICE!
Unlike the setup of the initial configuration a loaded one already
i
exists. However, since the configuration to be modified must be
loaded (i.e. made current) in order to configure the Access
Engine, an error message appears at this point.
Bosch Sicherheitssysteme GmbH
Check the license file contents in the License dialog are
correct.
– If these do not match the file imported in the BIS
Manager, you can copy the imported file for the
configuration using the Read button.
Make sure that the correct login server is entered in the
Server structure dialog (this applies mainly to distributed
systems).
If the BIS Manager has not yet been started:
– Start the BIS Manager by double-clicking the desktop
icon.
– Log in with your username and password.
On System start/stop tab, click the Start button to the left
of the Configuration Browser entry (not the button
marked BIS Server).
Perform steps 6 to 9 from Section 4.2.1 Creating an initial
configuration, Page 25.
Installation manual
System configuration | en
F.01U.028.713 | V 2.3.0.1 | 2009.11
27