Operating Procedures - Zip 303061 Installation And Operating Instructions Manual

Operating Procedures

Tap Operation
Safety feature.
Zip Hydroboil has a unique safety device designed to reduce the incidence of accidental operation of the tap.
The tap can be "Locked" to prevent the Hydroboil from dispensing hot water.
In order to "lock" the tap, ensure the safety button is protruding from the right hand side of the control
panel and the locked indicator is shown.
This can be achieved by pressing the button and simultaneously rotating it until the groove allows the button
to pop out. Once the button is in the extended position, the tap will be "Locked" and unable to dispense hot
water (unless the button is pressed).
Disengage safety feature.
Press and simultaneously rotate (aprox 90 degrees) the safety button on the right hand side of the control
panel, until it latches in the closed position, and the unlocked indicator is shown.
Warning: The unit is now capable of dispensing boiling water without the safety feature.
Locked / unlocked indicators
Continuous operation
Normal operation
Dispensing Boiling water:
Zip Hydroboil is fitted with a safety, two-way cool-touch safety tap for instant boiling water.
Normal operation (for filling cups and small containers)
To activate the tap, press the safety button on the right side of the control panel and while holding the
button in, gently push the lower end of the tap paddle inwards and boiling water will flow until the tap
paddle is released.
Continuous operation (for filling, tea pots, saucepans and large containers )
Press the safety button on the right side of the control panel and while holding the button in, Lift the tap
paddle until it locks into a horizontal position, the button can now be released and boiling water will flow
until the paddle is returned to its normal vertical position. This operation allows a vessel to be filled without
holding your hand where it may be affected by steam.
Page 10 of 24
804546 03.17 1.00