• Please leave these instructions with the end user after installation. • To ensure you have a copy of the latest instructions visit www.zipwater.co.uk. Installation instructions & user manual Technical support 9120-25693 v3.00 Oct 2018 - ZIP CEX Tel: 0345 6 005 005 email: service@zipindustries.co.uk www.zipwater.co.uk...
Installation instructions & user manual Technical support 9120-25693 v3.00 Oct 2018 - ZIP CEX Tel: 0345 6 005 005 email: service@zipindustries.co.uk www.zipwater.co.uk...
Page 4
No other fittings or appliances which decrease the water flow to the shower may be installed. Installation instructions & user manual Technical support 9120-25693 v3.00 Oct 2018 - ZIP CEX Tel: 0345 6 005 005 email: service@zipindustries.co.uk www.zipwater.co.uk...
Page 5
• Incoming water temperature must not exceed that stated in Technical data. • The Zip InLine is intended for connection to mains supply only. In any other case please contact Zip on 0345 6 005 005 for advice. • Zip Water UK cannot be held liable for any damages caused by failure to observe these instructions.
The required outlet temperature can be entered on a keypad and can be read off the digital display. APPROVALS Zip InLine CEX-O and CEX-U are VDE approved to the LVD and EMC directives and are CE marked. Zip InLine CEX-O and CEX-U have been examined, tested and found when correctly fitted to comply with the requirements of the United Kingdom Water Regulations / Byelaws (Scotland).
The appliance must not be subject to more than 1.0 MPa (10 bar). Instantaneous performance calculations Temperature rise °C = (Nominal power rating (kW) x 14.3) Flow per minute (litres) Installation instructions & user manual Technical support 9120-25693 v3.00 Oct 2018 - ZIP CEX Tel: 0345 6 005 005 email: service@zipindustries.co.uk www.zipwater.co.uk...
This is particularly relevant when the heater is located in a cupboard or any concealed location. For guidance please call Zip on 0345 6 005 005. Installation instructions & user manual Technical support 9120-25693 v3.00 Oct 2018 - ZIP CEX...
• Open and close the hot water tap until no more air emerges from the pipe and all air has been eliminated from the water heater. Installation instructions & user manual Technical support 9120-25693 v3.00 Oct 2018 - ZIP CEX Tel: 0345 6 005 005 email: service@zipindustries.co.uk www.zipwater.co.uk...
3 mm in all poles and be protected by a suitably rated RCD. Installation instructions & user manual Technical support 9120-25693 v3.00 Oct 2018 - ZIP CEX Tel: 0345 6 005 005 email: service@zipindustries.co.uk www.zipwater.co.uk...
Page 12
Make sure not to trap any cables Fig. 6 between the front cover and the body of the appliance. Installation instructions & user manual Technical support 9120-25693 v3.00 Oct 2018 - ZIP CEX Tel: 0345 6 005 005 email: service@zipindustries.co.uk www.zipwater.co.uk...
Page 14
Installation instructions & user manual Technical support 9120-25693 v3.00 Oct 2018 - ZIP CEX Tel: 0345 6 005 005 email: service@zipindustries.co.uk www.zipwater.co.uk...
Page 15
Installation instructions & user manual Technical support 9120-25693 v3.00 Oct 2018 - ZIP CEX Tel: 0345 6 005 005 email: service@zipindustries.co.uk www.zipwater.co.uk...
• When switching on the power supply for the first time, the value “88“ flashes in the display. If not, please carefully read the Re installation section Installation instructions & user manual Technical support 9120-25693 v3.00 Oct 2018 - ZIP CEX Tel: 0345 6 005 005 email: service@zipindustries.co.uk www.zipwater.co.uk...
Page 18
10 - 30 seconds of water flow. • Explain operation of the appliance to the end user and leave the operating instructions for their reference. • Complete the product registration card and return it to Zip or register the product on line at www.zipwater.co.uk/product-registration. Reinstallation Fig.
Page 19
• Move jumper from pin 1 to pin 2 (see figure 10). • Reconnect the power supply to the appliance. Fig. 10 Installation instructions & user manual Technical support 9120-25693 v3.00 Oct 2018 - ZIP CEX Tel: 0345 6 005 005 email: service@zipindustries.co.uk www.zipwater.co.uk...
Temperature Limit: Set maximum temperature limitation (°C) Temperature limit Signal: Quality of radio contact with diagnostic display Signal Installation instructions & user manual Technical support 9120-25693 v3.00 Oct 2018 - ZIP CEX Tel: 0345 6 005 005 email: service@zipindustries.co.uk www.zipwater.co.uk...
Page 21
In order to modify system parameters it is necessary to remove the jumper from the main PCB as described under “Deactivation of the lock level”. Installation instructions & user manual Technical support 9120-25693 v3.00 Oct 2018 - ZIP CEX Tel: 0345 6 005 005 email: service@zipindustries.co.uk www.zipwater.co.uk...
• Switch off: press program key simultaneously for at least 3 sec. The display briefly confirms the deactivation by “--“. Installation instructions & user manual Technical support 9120-25693 v3.00 Oct 2018 - ZIP CEX Tel: 0345 6 005 005 email: service@zipindustries.co.uk www.zipwater.co.uk...
“MAX” on the display. • Reducing the flow rate will enable the required temperature to be delivered. Installation instructions & user manual Technical support 9120-25693 v3.00 Oct 2018 - ZIP CEX Tel: 0345 6 005 005 email: service@zipindustries.co.uk www.zipwater.co.uk...
• The appliance activates the heater after approx. 10 seconds of continuous water flow. Installation instructions & user manual Technical support 9120-25693 v3.00 Oct 2018 - ZIP CEX Tel: 0345 6 005 005 email: service@zipindustries.co.uk www.zipwater.co.uk...
• Repairs should only be carried out by competent persons familiar with electric instantaneous water heaters. • All service work should be performed by an authorized Zip service engineer – for details of the full range of services available call Zip on 0345 6 005 005.
Zip Water UK warrants that, should any part fail within 12 calendar months of installation, that part will be repaired or replaced free of charge by Zip or its Distributor or Service Provider, except as set out below, provided the appliance is installed and...
Page 27
Furthermore, this warranty does not displace any statutory warranty, but, to the extent to which Zip is entitled to do so, the liability of Zip under any statutory warranty will be limited at Zip’s option to the replacement of the appliance or supply of equivalent...
Page 28
Zip Water UK 14 Bertie Ward Way, Dereham, Norfolk NR19 1TE 0345 6 005 005 sales@zipindustries.co.uk www.zipwater.co.uk Installation instructions & user manual Technical support 9120-25693 v3.00 Oct 2018 - ZIP CEX Tel: 0345 6 005 005 email: service@zipindustries.co.uk www.zipwater.co.uk...