Precautions - AEMC 1227 User Manual

Thank you for purchasing the Thermo-Anemometer Data Logger Model 1227. For best results from your
instrument:

read these operating instructions carefully,

comply with the precautions for use.
WARNING, risk of DANGER! The operator must refer to these instructions whenever this
danger symbol appears.
Information or useful tip.
Battery.
Magnet.
The product has been declared recyclable after analysis of its life cycle in accordance with
the ISO14040 standard.
AEMC has adopted an Eco-Design approach in order to design this appliance. Analysis of
the complete lifecycle has enabled us to control and optimize the effects of the product on
the environment. In particular this appliance exceeds regulation requirements with respect
to recycling and reuse.
Indicates conformity with European directives and with regulations covering EMC.
Indicates that, in the European Union, the instrument must undergo selective disposal in
compliance with Directive WEEE 2002/96/EC. This instrument must not be treated as
household waste.
The Model 1227 is designed to operate with system voltages less than 75V

Precautions

This instrument is compliant with safety standard IEC 61010-2-030, for voltages up to 5V with respect to ground.
Failure to observe the following safety instructions may result in electric shock, fire, explosion, and damage to the
instrument and/or the installation in which it is located.

The operator and/or the responsible authority must carefully read and clearly understand all precautions
to be taken prior to using the instrument. Thorough knowledge and awareness of electrical hazards are
essential when using this instrument.

Observe the conditions of use, including temperature, relative humidity, altitude, pollution degree, and
location of use.

Do not use the instrument if it appears damaged, incomplete, or improperly closed.

Before each use, check the condition of the housing and accessories. Any item on which the insulation is
deteriorated (even partially) must be set aside for repair or disposal.

Always hold the sensor handle, and keep your fingers away from the propeller.

All troubleshooting and metrological checks must be done by accredited personnel.
Thermo-Anemometer Data Logger Model 1227
.
DC
1