Cautions, Warnings, And Regulatory Information - Simplex 4100ES Installation Manual

Hide thumbs Also See for 4100ES:
Table of Contents

Advertisement

Cautions, Warnings, and Regulatory Information

Cautions
READ AND SAVE THESE INSTRUCTIONS
and
followed to avoid damage to this product and associated equipment. Product operation and reliability depend upon proper
Warnings
installation.
DO NOT INSTALL ANY SIMPLEX® PRODUCT THAT APPEARS DAMAGED
inspect the contents of the carton for shipping damage. If damage is apparent, immediately file a claim with the carrier and notify
an authorized Simplex product supplier.
ELECTRICAL HAZARD
be performed by a representative or authorized agent of your local Simplex product supplier.
STATIC HAZARD
• Ground yourself before opening or installing components.
• Prior to installation, keep components wrapped in anti-static material at all times.
EYE SAFETY HAZARD -
safety limits. Do not use magnification (such as a microscope or other focusing equipment) when viewing the output of this device.
SULFURIC ACID WARNING-
destroy fabric. Replace any leaking or damaged battery while wearing appropriate protective gear. If you come in contact with
sulfuric acid, immediately flush skin or eyes with water for 15 minutes and seek immediate medical attention.
FCC RULES AND REGULATIONS
device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a 
residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.
IMPORTANT: Verify FACP System Programmer, Executive, and Slave Software compatibility
Copyright and
© 2017 Johnson Controls. All rights reserved. All specifications and other information shown
Trademarks
were current as of document revision and are subject to change without notice. Additional
listings may be applicable, contact your local Simplex® product supplier for the latest status.
Listings and approvals under Simplex Time Recorder Co. Simplex, and the product names
listed in this material are marks and/or registered marks. Unauthorized use is strictly
prohibited. NFPA 72 and National Fire Alarm Code are registered trademarks of the National
Fire Protection Association (NFPA).
Microsoft and Windows are registered trademarks of Microsoft Corporation.
VESDA is a trademark of Xtralis Pty Ltd.
NFPA 72 and National Fire Alarm and Signaling Code are registered trademarks of the
National Fire Protection Association (NFPA).
- Follow the instructions in this installation manual. These instructions must be
- Disconnect electrical field power when making any internal adjustments or repairs. All repairs should
- Static electricity can damage components. Handle as follows:
Under certain fiber optic application conditions, the optical output of this device may exceed eye
Battery contains sulfuric acid, which can cause severe burns to the skin and eyes and can
PART 15
-
- This equipment has been tested and found to comply with the limits for a Class A digital
when installing, or replacing system components. Refer to the Technical
Support Information and Downloads website for compatibility information.
- Upon unpacking your Simplex product,
i

Advertisement

Table of Contents

Troubleshooting

loading
Need help?

Need help?

Do you have a question about the 4100ES and is the answer not in the manual?

Table of Contents

Save PDF