Table of Contents
Advertisement
Testing the System (Continued)
Testing the System
Testing the System
Testing the System
Go- - - - No
Go
Go
Go
No- - - - Go Test
No
No
Go Test
Go Test Mode
Go Test
Mode
Mode
Mode
Conducting this test with your hand wrapped around the transmitter will cause inaccurate results.
Conducting this test with your hand wrapped around the transmitter will cause inaccurate results.
Conducting this test with your hand wrapped around the transmitter will cause inaccurate results.
Conducting this test with your hand wrapped around the transmitter will cause inaccurate results.
If a button is pressed on a transmitter tha
If a button is pressed on a transmitter that has been programmed to set
If a button is pressed on a transmitter tha
If a button is pressed on a transmitter tha
( ( ( ( Stay
Stay) ) ) ) , or
, or Disarm
Disarm, the system will exit the Go/No Go Test mode and the programmed action will
Stay
Stay
, or
, or
Disarm
Disarm
occur.
occur.
occur.
occur.
The Go-No-Go tests is used to verify adequate RF signal strength from the proposed transmitter location, and
allow you to reorient or relocate transmitters if necessary, before mounting the transmitters permanently. This
mode is similar to the RF Sniffer Mode, except that the wireless receiver gain is reduced. This will enable you to
make sure that the RF signal from each transmitter is received with sufficient signal amplitude when the system
is in the normal operating mode. During Go/No-Go mode the system beeps every 30-40 seconds.
Enter Go/No
Enter Go/No
Enter Go/No
Enter Go/No- - - - Go Test mode
Go Test mode
Go Test mode
Go Test mode
1.
Enter Installer Code (4112) + 51 (on the Gateway touchpad).
Exit Go/No- - - - Go Test mode
Exit Go/No
Exit Go/No
Exit Go/No
Go Test mode
Go Test mode
Go Test mode
1.
Select "Disarmed"+ Enter Installer Code (4112).
Rebooting the System
Rebooting the System
Rebooting the System
Rebooting the System
The Reboot function allows you to restart the system if required. To reboot the system perform the following
via the AlarmNet 360 app when the "Advanced" icon is selected from the Installer Tools screen or the Installer
Programming screen.
Step
Step
Step
Step
1.
Select the "Reboot" button. A confirmation screen appears.
2.
Select "Yes" to reboot the Gateway.
NOTE: : : : After the reboot sequence is complete it is recommended that you perform a "Walk Test" to verify that
NOTE
NOTE
NOTE
all transmitters are operational in the system.
A hard reboot can also be performed locally at the Gateway using the following procedure.
Step
Step
Step
Step
1.
Remove the rear Gateway's cover, the panel's tamper alarm will sound.
Using a precision screwdriver, paperclip or equivalent, depress the center (Reboot) recessed
2.
microswitch to reboot the panel.
REAR COVER
SCREW
, the system will exit the Go/No Go Test mode and the programmed action will
, the system will exit the Go/No Go Test mode and the programmed action will
, the system will exit the Go/No Go Test mode and the programmed action will
Lyric Gateway Installation and Reference Guide
t has been programmed to set Arm Away, Arm
t has been programmed to set
t has been programmed to set
Action
Action
Action
Action
Action
Action
Action
Action
RJ45
ETHERNET
RECEPTACLE
MICROSWITCHES
- 27 -
Arm Away, Arm
Arm Away, Arm Home
Arm Away, Arm
Home
Home
Home
POWER SUPPLY
RECEPTACLE
BATTERY
RECEPTACLE
DETAIL A
Advertisement
Table of Contents
