Wall Mounting; Desktop Mounting; Install The Desk Stand - Honeywell LyricLCP300-L Installation And Reference Manual

Lyric Gateway Installation and Reference Guide
Installing Installing the Installing Installing the the Gateway the Gateway (Continued) Gateway Gateway
Install the replacement battery Install the replacement battery Install the replacement battery Install the replacement battery
1. Install a replacement battery pack (LCP500-4B [p/n 300-03864-AIO] OR LCP500-24B [p/n 300-03866-
AIO]) into the Gateway.
2. Close the hinged battery retainer.
3. Connect the battery pack connector to the receptacle on the Gateway.
4. Align the slots on the back of the Gateway with the hooks on the rear cover/wall mount as shown below.
5. Once attached, insert the screw to secure the rear cover/wall mount.
6. Plug the power supply into a 24-hour, 110VAC unswitched outlet. Upon power-up, the LEDs will flash
alternately.
7. When the power-up sequence is complete, the green Disarmed LED and the green shield will be lit.
NOTE: If a Cellular Communication Module is being installed, verify the module's signal strength before NOTE: NOTE: NOTE:
selecting a final mounting location. Refer to Checking the Signal Strength in the Communications
Module section.
Wall Mou

Wall Mounting

Wall Mou Wall Mou nting nting nting
NOTE: NOTE: When selecting a location for the Lyric Gateway, be sure to provide a separation of at least 10 feet NOTE: NOTE:
between 2.4GHz devices such as Wi-Fi Routers/Access Points.
For wall mounting follow the steps and refer to the figure below.
1. Feed the field wiring through the appropriate openings in the wall mount.
2. Attach the wall mount to a sturdy wall using the four provided screws.
3. Install an additional mounting screw in the case tamper.
4. Align the slots on the back of the Gateway with the hooks on the wall mount as shown below.
5. Once attached, insert the screw to secure the Lyric to the wall mount.
WALL
SURFACE
MOUNTING
SCREW
(4) TYP.
REAR
COVER /
MOUNTING
BRACKET
TAMPER
SCREW

Desktop Mounting

Desktop Mounting
Desktop Mounting Desktop Mounting
NOTE: When selecting a location for the Lyric Gateway, be sure to provide a separation of at least 10 feet NOTE:
NOTE: NOTE:
between 2.4GHz devices such as Wi-Fi Routers/Access Points.
The Desk Stand (LCP300-DK) can be installed in two positions that provide a viewing angle of 30 degrees or 60
degrees. Follow the steps and refer to the figures below.
Install Install the LCP300 Install Install the LCP300 the LCP300- - - - DK the LCP300 DK Desk Stand DK DK
1. Align the slots on the back of the Gateway with the hooks on the desk stand as shown below.
2. Insert the stand into the slots on the rear case to provide the desired viewing angle and slide up to lock in
place.
REAR COVER /
MOUNTING
BRACKET
Desk Stand Desk Stand Desk Stand
1
SCREW
- 8 -
RJ45 ETHERNET
POWER SUPPLY
RECEPTACLE RECEPTACLE
BATTERY
RECEPTACLE
MICROSWITCHES
DETAIL A
1