Operating The Balance With The Battery; Specifications - Scale House GAI420 Operation Manual

(2) Instruction for tare subtraction (zero adjustment)
C1 C2 Code
T (SP) 54H
(3) Setup of output control
C1 C2 Code
Ｏ
0 4FH
Ｏ
1 4FH
Ｏ
2 4FH
Ｏ
3 4FH
Ｏ
4 4FH
Ｏ
5 4FH
Ｏ
6 4FH
Ｏ
7 4FH
Ｏ
8 4FH
Ｏ
9 4FH
※The output controls executed with commands [O0] - [O7] work the same as the output controls executed through
function setup on the main unit of the balance.
The commands [O8] and [O9] are data request commands issued to the balance.
※Once any command from [O0] to [O9] is executed, the balance runs that function until another command is entered.
However, if the balance is switched off and on again, the output control is reset to the initial function (function set
value).
10.5.3 Response Output
(1) Response output format
Composed of five characters, including the terminators (CR = 0DH; LF = 0AH)
1 2 3
A1 A2 A3
(2) Types of response outputs
A1 A2 A3
A 0 0
E 0 1

11. Operating the Balance with the Battery

This function can be used only when the balance is battery-operated.
11.1

Specifications

 Built-in nickel-cadmium battery
 Charging time: Approximately 12 hours
40
Description
Instruction for tare
20H subtraction (zero
adjustment)
30H Stop output
31H Output continuous at all times
32H Output continuous if stable (stop output if unstable)
33H Outputs once by pressing
whether stable).
34H Outputs once if stable. Outputs if the balance is stable when
a sample is loaded after the preceding sample has been
removed and the balance indicated zero, or less.
35H Outputs once if stable, and stops output when unstable. Even
if the sample is not replaced, the balance is output once when
it stabilizes next time (including the zero indication).
36H Outputs once if stable, and outputs continuously when
unstable. Even if the sample is not replaced, output of the
balance stops when it stabilizes after being output once.
37H
Pressing Memory
when stable.
38H Output once immediately.
39H Output once after stabilization.
4 5
CR LF
Code
41H 30H 30H
45H 30H 31H
Value Response
A00: Normal end
E01: Tare subtraction cannot be
None
executed due to an error in
the weight value.
Description
Memory key (irrespective of
key causes the balance to output once
Description
Normal end
Command error
(Abnormal command received; other errors)