Setting Up Limit Values By Inputting Values - Scale House GAI420 Operation Manual

8.3 Setting up Limit Values by Inputting Values

1 Starting the limit function
Continuous pressing
2 Opening the value input screen
3 Entering a value
4 Selecting a digit
5 Repeat Steps 3 and 4
6 Saving the lower-limit value
7 Setting up the upper-limit value
Press and hold down the
Release the key when [L.
displayed.
The currently set lower-limit value
flashes.
Key released
Press the
All the digits are displayed, with the one
on the right end flashing. This flashing
digit is the one that can be changed.
Press the
Pressing the key repeatedly changes
the flashing value until the desired
number is entered.
Press the
The flashing moves to the digit on the
immediate left. Each time the key is
pressed, the flashing digit moves one
position left. When the leftmost digit is
selected, the flashing advances to the
rightmost digit position.
Enter the lower-limit value by selecting
a value with the
moving the digits with the
key, as needed.
Press the
After saving the lower-limit value, the
balance displays it briefly and proceeds
to the next setup.
※If one-point setup was chosen, the
setup is complete.
The display changes to [H.
indicating that the upper-limit value can
be set.
If there is an upper-limit value already
set, that value will flash.
Set key.
SEt ] is
Zero/Tare key.
Zero/Tare key again.
Function key.
Zero/Tare key and
Function
Memory key.
SEt ],
29