Charging Procedure - Yardworks 060-2374-4 Instruction Manual

12
model no. 060-2374-4 | contact us: 1.866.523.5218

CHARGING PROCEDURE

NOTE: The battery is not shipped fully charged. It is recommended to fully charge it before first
use to ensure that maximum run time can be achieved. This lithium-ion battery will not develop
a memory and may be charged at any time.
1. Plug the charger into an AC power outlet.
2. Insert the battery pack (1) into the charger (2).
This is a diagnostic charger. The charger LED lights (3) will illuminate in specific order to com-
municate the current battery status. They are as follows:
CHARGING PROCEDURE (LED INDICATOR)
BATTERY IS CHARGING:
FULLY CHARGED:
BATTERY IS TOO WARM:
(REMOVE FOR APPROX. 30
MINUTES TO ALLOW TO COOL)
NO BATTERY PRESENT
False Defect Note:
When the battery is inserted into the char-
ger, and the status LED shows solid or-
ange, remove the battery from the charger
for 1 minute, then insert. If the status LED
indicates normal, then the battery pack
is good. If the status LED is still orange,
please check if the battery pack is too
warm or too cold. If its temperature is nor-
mal, the battery pack or the charger needs
to be repaired.
NOTE When the red indictor flickers, pull out the battery from the charger and insert again
:
within 2 hours. If the indictor shows charging, that means the battery is good. After 2 hours,
please pull out the battery and also pull out the AC power plug of the charger for 1 miniute, and
then insert the AC power plug and the battery again. If the indictor shows charging, that means
the battery is good. If not, the battery needs to be changed.
RED
RED
RED
GREEN
RED ORANGE
RED OFF