Advertisement
Please note
• Any work on the mains power supply must only be completed by trained specialists.
• The installation must be completed in accordance with country-specific guidelines/
standards.
• Disconnect the 230 V power supply before starting the installation!
• As a precautionary measure, the power supply of the light should always be fitted
with a (250 VAC, 10 A) type C fuse in accordance with EN60898-1.
• The device must not be installed on conductive surfaces.
• The motion detector is only suitable for internal use.
• Before replacing a lamp, the power supply to the detector/installation
must be disconnected.
• Faulty lamps can cause a short-circuit thereby permanently damaging the device.
• To ensure the correct functionality of the detector, a minimum distance of 1 m
must be maintained to any lights installed at the same height.
• Any lights installed underneath the detector or that are located in the coverage
area can impair the functionality of the detector.
• If there are any functional faults, such as a continuous light or the light switching
on/off independently, please refer to «Troubleshooting» on page 19.
Functions
The SG360P dimmer motion detector reacts to the heat radiated from moving bodies. If
a person approaches the monitored area, the connected light is automatically switched
on. If the person leaves this area, the light is switched off after the preset follow-up time.
Installation
The SG360P dimmer motion detector is suitable for flush ceiling installations and inter-
nal use only. The ideal installation height is 2–4 m.
– 3 –
Advertisement
