Zublin SG360P Dimm Operating Instructions Manual page 18

Button Function button
This button is used to manually switch the light on and off.
This button is used to automatically or semi-automatically set the operat-
ing mode. (Remote control when in programming mode).
When the button
LED flashes once.
The detector is now in automatic mode.
If the button is pressed again, three beeps will sound and the red LED will
flash three times.
The detector is now in semi-automatic mode.
Channel selection:
for DM1 programming
for DIM2 programming
(the SG360P dimmer does not have a second channel (CH2)
Button to control the dimming function using the IR remote control
By pressing the button
on the controllers. All of the default parameters are reset on the remote
control:
100 lx
0 %
The next time the button
ferred to the detector.
is pressed, a beep sounds from the buzzer and the
, the detector is reset and uses the value set
5 min
Channel CH1
is pressed, these parameters are trans-
– 18 –
1 min