Button
Function button
Test mode is activated by pressing the button
in programming mode). The light is switched on for three seconds and then
remains switched off for 6 s.
By pressing the button
tion.
TEST mode is terminated by pressing one of the following buttons:
,
sponding command.
By activating the button
hours (remote control when in programming mode) and then switches
back to automatic operation. The LED slowly flashes simultaneously.
To switch back to automatic operation, simply press the same button
again.
By pressing one of the following buttons
the 6 h mode is terminated and the required function is completed. In the
event of a power failure, the detector switches back to automatic operation
following the warm-up phase.
By activating the button
hours (remote control when in programming mode) and then switches
back to automatic operation. The LED slowly flashes simultaneously.
To switch back to automatic operation, simply press the same button
again.
By pressing one of the following buttons
the 6 h mode is terminated and the required function is completed. In the
event of a power failure, the detector switches back to automatic operation
following the warm-up phase.
again, it switches back to automatic opera-
,
,
or
, the detector switches the light on for six
, the detector switches the light off for six
– 17 –
(remote control when
and the detector completes the corre-
,
,
,
,
,
or
,
or