GLP X4 ATOM series Instruction Manual page 9

Attaching the Yoke Bracket / Floor Stand
The yoke bracket / floor stand snaps on to the
connector sockets on the outside of the head.
To attach to a bracket to an X4 ATOM head,
slide the bracket forwards onto two connector
sockets until the bracket locks in place.
To release the bracket, push the lock pins on
both sides of the bracket an slide backwards.
Operating on the Floor (Upright)
The X4 ATOM can be placed upright on a floor
or other level surface using the included yoke
bracket/floor stand unfolded as shown to right.
Attach the bracket as described above. Loosen
the tilt lock screw, spread the inner and outer
brackets, tilt the head to the desired angle, and
tighten the tilt lock screw.
Hanging a single head
Heads can be rigged individually on a truss
using a suitable rigging clamp fastened to the
yoke bracket/floor stand as shown. Loosen the
tilt lock screw to adjust tilt angle. Secondary
attachment is also required.
X4 Atom User Manual (v.0.3)
German Light Products GmbH WWW.GLP.DE
Push pins to release
9