REINSTALLING THE LOADER
ADJUSTING THE HEIGHT OF
THE LIFTING STAND
If the stand does not get hooked and fold up
successfully, readjust the height of lifting stand.
1. Raise the boom until the bucket-fulcrum-pin comes
up to the height of the boom-fulcrum-pin.
2. Roll back the bucket to maximum.
(1) Bucket fulcrum pin
(2) Boom fulcrum pin
3. Stop the engine.
4. Make sure that the stand lever is at its low position
as shown in the following figure.
(1) Stand lever
5. Apply the adjusting bolts in the parts box to both the
right and left stand adjusting blocks as shown in the
following figure.
156
(A) Same height
ADJUSTING THE HEIGHT OF THE LIFTING STAND
(1) 2-Adjusting block
(2) 2-M16 Adjusting bolt
(3) 2-M16 Lock nut
IMPORTANT :
• Be sure to apply the adjusting bolts all the
way to prevent the damage of the stand.
NOTE :
• There is no need to tighten up the lock nuts.
(A) About 13 mm
BX23S, LA340, BT603