Table of Contents
Advertisement
HOW TO REMOVE THE LOADER
REMOVING THE LOADER
HOW TO REMOVE THE
LOADER
WARNING
To avoid personal injury or death:
• Make sure that an approved bucket is attached
before removing the loader from the tractor.
• For removing the loader, choose flat and hard
ground, preferably concrete.
• If the ground surface is soft, place suitable
planks on the ground for the bucket and the
stand.
• When starting the engine or using the loader-
control-lever, always sit in the operator's seat.
• Make sure that the bucket and the stand are at
ground level.
1. Set the engine speed to the following speed, and
then raise the boom until the bucket pin is the
height of the boom fulcrum pin.
Engine speed
2. Dump the bucket fully.
(1) Bucket pin
(2) Boom fulcrum pin
3. Slide
the
stand
completely, and release the stand from the stand
hook.
BX23S, LA340, BT603
1800 rpm
(A) Same height
lever
downward
direction
(1) Stand lever
(2) Stand
4. Get the bucket rolled back until its bottom is
positioned the following angle with respect to the
ground surface.
(A) Angle between ground sur-
face and bucket bottom
Angle between ground surface and bucket
bottom (A)
REMOVING THE LOADER
(3) Stand hook
About 20 degrees
147
Advertisement
Table of Contents
