Table of Contents
Advertisement
HOW TO REMOVE THE BACKHOE
REMOVING THE BACKHOE
HOW TO REMOVE THE
BACKHOE
WARNING
To avoid serious injury or death:
• Before starting the engine, always sit in the
operator's seat of the tractor.
• Before getting off the tractor, make sure that the
PTO lever is off and the range-gear-shift-lever is
in the neutral position. Then set the parking
brake.
• Keep hands, feet, and body from between the
tractor and the backhoe. Never allow any part of
body under the machine.
• Before leaving the operator's seat of the
backhoe, fully lower the boom to the ground.
• Before removing the backhoe, set the swing-
lock-pin.
IMPORTANT :
• Before removing the backhoe, set the engine
speed as follows.
Engine speed
• For removing the backhoe, locate the tractor,
the loader, and the backhoe on a flat level and
hard surface, preferably concrete.
If the surface is soft, place a board on the
ground for the bucket and stabilizers.
1. Set the swing-lock-pin to prevent the pivoting of the
boom before removing the backhoe.
(1) Swing lock pin
2. Stand beside the rear tire, fold the boom and dipper
completely, and dump the bucket to approximately
60 degrees.
BX23S, LA340, BT603
Approximately 1800 rpm
3. Keep the stabilizer pads at height of the following
value.
(A) Height of stabilizer pads
Height of stabilizer pads
REMOVING THE BACKHOE
About 381 mm (15.0 in.)
161
Advertisement
Table of Contents
