Removing The Loader - Kubota BX25DLB Operator's Manual

102 REMOVING THE LOADER

REMOVING THE LOADER
To avoid personal injury:
A Make sure an approved bucket is attached
before removing the loader from the tractor.
A For removing the loader, choose flat and hard
ground, preferably concrete.
A If the ground surface is soft, place suitable
planks on the ground for the bucket and stand.
A When starting the engine or using the loader
control lever, always sit in the operator's seat.
A Make sure the bucket and stand are at ground
level.
1. Raise the boom until the stand can be rotated.
2. Stop the engine.
3. Remove the spring pin holding the stand to the boom.
4. Slide the stand leftward and rotate it until the hole in
the stand and pin on the boom are aligned.
Then slide the stand rightward and insert the spring pin
as shown.
(1) Stand
(2) Spring pin
5. Start the engine and run at idle.
6. Dump the bucket approximately 20 degrees.
7. Lower the boom and raise the front wheels slightly.
(1) Stand
A Lift the front wheels with the bucket. Do not attempt to
lift them with the stand.
8. Stop the engine.
9. Remove the mounting pins from the loader side frame
and retain them in the plate of side frame.
(1) Mounting pin