Summary Of Parameter Settings; Group 0 User Parameters - Delta VFD-E User Manual

Chapter 4 Parameters|

4.1 Summary of Parameter Settings

: The parameter can be set during operation.

Group 0 User Parameters

Parameter Explanation
00.00 Identity Code of the
AC motor drive
00.01 Rated Current
Display of the AC
motor drive
00.02 Parameter Reset
Start-up Display
00.03
Selection
Content of Multi-
00.04
function Display
4-2
Settings
Read-only
Read-only
0: Parameter can be read/written
1: All parameters are read only
6: Clear PLC program (NOT for VFD*E*C
models)
9: All parameters are reset to factory settings
(50Hz, 230V/400V or 220V/380V depends on
Pr.00.12)
10: All parameters are reset to factory
settings (60Hz, 220V/440V)
0: Display the frequency command value
(Fxxx)
1: Display the actual output frequency (Hxxx)
2: Display the content of user-defined unit
(Uxxx)
3: Multifunction display, see Pr.00.04
4: FWD/REV command
5: PLCx (PLC selections: PLC0/PLC1/PLC2)
(NOT for VFD*E*C models)
0: Display the content of user-defined unit
(Uxxx)
1: Display the counter value (c)
2: Display PLC D1043 value (C) (NOT for
VFD*E*C models)
3: Display DC-BUS voltage (u)
4: Display output voltage (E)
Revision November 2007, 03EE, SW--PW V1.10/CTL V2.10
Factory
Customer
Setting
##
#.#
0
0
0