Vislink UltraDecoder Operator's Manual page 50

This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.
Properly shielded and grounded cables and connectors must be used to meet FCC emission
limits. Vislink Ltd is not responsible for any radio or television interference caused by using
other than recommended cables or connectors.
Unauthorized changes or modifications to the equipment could void the user's authority to
operate the equipment.
These devices comply with part 15 of the FCC Rules. Operation is subject to the following
two conditions:
1. These devices may not cause harmful interference
2. These devices must accept any interference received, including interference that may
cause undesired operation.
This FCC Statement applies to these Vislink Ltd models:

UltraDecoder
Pertinent testing documentation is available for verification.
Issue: 4
Ref: ULTD-ASUM-7001
UltraDecoder Operators Manual
Remote Control
Copyright © 2016 Vislink plc
42