Table of Contents
Advertisement
im Vertrieb von
7.1.2 Switch OUT-IN Combinations in the Dual-Link Mode
To switch an input to an output in the dual-link mode, via the front panel
1
buttons
1.
Press an OUTPUT button (either 1, 2, 3, 4 or ALL).
The selected OUTPUT button illuminates brightly, as does the 7-segment
display.
2.
Press an INPUT button (either 1, 2 or OFF)
The selected input switches to the selected output, and that input button
illuminates brightly. The digits displayed in the 7-segment display change as
appropriate.
7.2 Confirming Settings
You can work in the AT ONCE or the CONFIRM mode (see section 7.2.1).
When the VS-48HDxl operates in the AT ONCE mode, pressing an
OUT-IN combination implements the switch immediately. In the CONFIRM
mode, the TAKE button must be pressed to authorize the switch.
In the AT ONCE mode, you save time as execution is immediate and actions
require no user confirmation. However, no protection is offered against
changing an action in error.
In the CONFIRM mode:
You can key-in several actions and then confirm them by pressing the
" TAKE" button to simultaneously activate the multiple switches
Every action requires user confirmation, protecting against erroneous
switching
Execution is delayed until the user confirms the action
Note that after ten seconds the VS-48HDxl will go to standby mode and the
buttons and the 7-segment display will illuminate less brightly.
1 For details of how to route an input to an output using the REMOTE connector, see section 6.9
2 For immediate switching
www.camboard.de
CAMBOARD Electronics
Operating the VS-48HDxl
, in the AT ONCE mode (see section 7.2), do the following:
Tel. 07131 911201
Fax 07131 911203
2
.
ce-info@camboard.de
21
Advertisement
Table of Contents
