Table of Contents
Advertisement
The terminal suddenly became unavailable while using
●
overseas
Check if usage amount exceeds the limit of maximum charges
for use. For use of "International roaming (WORLD WING)", the
limit of maximum charges for use is set in advance. If exceeding
the limit of maximum charges for use, pay the charges.
Cannot receive calls overseas
●
Is [Incoming call restriction while roaming] set to [Activate
restriction]?
P.120
→
No caller ID is notified/a notified caller ID is different from
●
that of the caller/functions for using phonebook contents
or Caller ID notification do not operate
Even if a caller notifies its caller ID, it is not displayed on the
terminal unless the network or network operator notifies it. And a
different caller ID may be notified depending on the network or
network operator you use.
Data management
■
●
Data transfer is not performed
Check if USB hub is used. If you use USB hub, operations may
not be performed correctly.
●
Data saved in microSD card is not displayed
Remove and attach the microSD card.
Images cannot be viewed
●
If image data is broken, a gray screen or
displayed.
P.27
→
etc. may be
126
■
Bluetooth function
The terminal cannot be connected to a Bluetooth
●
communication device/A Bluetooth communication
device cannot be found by search
Make Bluetooth communication device (commercial item)
registering stand-by state and then register the device on the
terminal. If you delete already registered device and register the
device again as a new device, delete the registrations on both
Bluetooth communication device (commercial item) and the
terminal and then perform registration of the devices.
●
Calls cannot be made from the terminal connecting to
external device such as car navigation or handsfree
device
If calls are made several times when the other party does not
answer or is out of service, the call to the number may be
disabled. In this case, turn terminal off and on.
■
External device connection
An external device which is connected via USB
●
connection is not recognized
Reconnect the external device. However, some devices may not
be detected.
Map/GPS
■
●
Cannot set AUTO-GPS service information
･ Check if the battery level is low and AUTO-GPS function stops.
If AUTO-GPS stops due to [Low-power operation settings],
AUTO-GPS service information cannot be set. In this case, set
[Low-power operation settings] to [Not suspend] or charge the
battery.
P.28 , P.101
→
･ Check if [AUTO-GPS operation settings] is unmarked.
→
P.113
→
P.101
Appendix/Index
Advertisement
Table of Contents
