Hide thumbs Also See for MF65M:

Advertisement

MF65M

Quick Start Guide

Configuration page: http://mifi.orange.cm
Password: admin

Advertisement

Table of Contents
loading

Summary of Contents for Zte MF65M

  • Page 1: Quick Start Guide

    MF65M Quick Start Guide Configuration page: http://mifi.orange.cm Password: admin...
  • Page 3: Getting To Know Your Device

    Getting to Know Your Device Appearance The following figure is for your reference only. 1. LED Indicators 2. Power Key 3. WPS Key 4. Charging/micro-USB Jack 5. (U)SIM Card Slot 6. microSDHC™ Card Slot NOTE: microSDHC logo is a trademark of SD-3C, LLC.
  • Page 4: Indicators

    Getting to Know Your Device Indicators When the device is powered on, the following icons may be lighting. For a description of the icons, refer to the following table. Indicator Status Description Error status. Not registered to the mobile network, no (U)SIM Red solid card inserted or no network service available.
  • Page 5 Getting to Know Your Device Blue solid You have unread messages. Blue blinking You have new messages. No unread messages. Red solid / The battery is low. Please blinking charge the battery. Green The battery is being charged blinking or in standby mode. Battery The battery level is middle or Green solid...
  • Page 6: Connection Scenarios

    Getting to Know Your Device Connection Scenarios The Orange 3G hotspot Wi-Fi MF65M creates a personal portable Wi Fi zone which allows several Wi-Fi enabled devices (for example PCs, Apple® iPhone, iPad or iPod touch, or mobile gaming devices such as Nintendo® DSi, Android devices including smartphones and tablets) to share a secure mobile internet connection.
  • Page 7: Installing Your Device

    Installing Your Device 1. Slide the back cover and remove it. NOTE: Do not remove the cover rudely. 2. Install a (U)SIM card to the (U)SIM card slot. WARNING! Your device does not support the micro-SIM card and nano-SIM card or any other non-standard SIM cards. To avoid damage to the device, do not use those cards or any card holders.
  • Page 8 Installing Your Device 3. Install the microSDHC card if necessary.
  • Page 9 Installing Your Device 4. Install the battery. 5. Close the back cover.
  • Page 10: Connecting To Your Device

    Connecting to Your Device Using Wi-Fi 1. Power on your device. 2. Make sure your computer or other client devices have enabled Wi-Fi, and search for available wireless networks.
  • Page 11 Connecting to Your Device NOTE: Refer to your Wi-Fi-enabled client device manual for further details on how to search for wireless networks. If you use a computer, you need to set your computer to obtain an IP address automatically. 3. Select the Wi-Fi name (SSID) of your device, and click Connect.
  • Page 12 Connecting to Your Device 4. Enter the Wi-Fi password if necessary, and click OK. NOTE: Refer to the chapter Getting to Know the Wi-Fi SSID and Password to get the default Wi-Fi SSID and password. 5. Wait until the client device is connected to your device successfully.
  • Page 13: Using A Usb Cable

    Connecting to Your Device Using a USB Cable 1. Connect a computer to your device with a USB cable. 2. Power on your device. The operating system detects and identifies new hardware, and automatically installs the hardware. NOTE: If the system does not automatically launch installation, you can click the device installation icon in My Computer to install the software.
  • Page 14: Configuration Page

    Logging in to the Mobile Hotspot Configuration Page 1. Make sure the connection between your device and the client device is correct. 2. Launch the Internet browser and enter http://192.168.0.1 or http:// mifi.orange.cm in the address bar. NOTE: It is recommended that you use IE (7.0 or later), Firefox (15.0 or later), Opera (10.0 or later), Safari (4.0 or later), or Google Chrome (10.0 or later).
  • Page 15 Changing the Wi-Fi SSID or Password 1. Log in to the Mobile Hotspot configuration page. 2. Select Settings > Wi-Fi Settings > Basic Settings. 3. Change the Network Name (SSID) or the Pass Phrase ( Password). 4. Click Apply. NOTE: If you forget the current password, press and hold the Power button and the WPS button to restore to the default password.
  • Page 16: Accessing The Internet

    Accessing the Internet After a client device is successfully connected to your device, you can access the Internet in Automatic or Manual mode. The default mode is Automatic. Mode Operation Your device is automatically connected to Automatic the Internet, and you can surf on the Internet through the client.
  • Page 17 Setting data limit The data usage is measured by your device. Your carrier’ s data usage accounting may differ. You can check how much data has been used during the time cycle you set, and set the data limit and warning. 1.
  • Page 18: Configuring Your Pc

    Configuring Your PC The following procedure describes how to configure the Internet Protocol in the Windows 7 operating system for your Wi-Fi connection. 1. Right-click Network and select Properties. 2. Select Change adapter settings.
  • Page 19 Configuring Your PC 3. Right-click Wireless Network Connection and select Properties.
  • Page 20 Configuring Your PC 4. Select Internet Protocol Version 4 (TCP/IPv4), and click Properties.
  • Page 21 Configuring Your PC 5. Select Obtain an IP address automatically and Obtain DNS server address automatically, and click...
  • Page 22: Warning And Notice

    Warning and Notice To the Owner • If inadequately shielded, some electronic devices, for example, the electronic system of vehicles, may be affected by the electromagnetic interference caused by the device. Consult the manufacturers of such devices before using the device if necessary. •...
  • Page 23 Warning and Notice • Do not use electronic transmission devices in aircrafts, at petrol stations or in hospitals. Observe and obey all warning signs, and power off the device in these conditions. • Do not touch the inner antenna area unless necessary. Otherwise the performance of the device may be affected.
  • Page 24 Warning and Notice To the Users • Use original accessories or accessories that are authorized. Using any unauthorized accessories may affect the performance of the device and violate the related national regulations about telecom terminals. • Avoid using the device near or inside metallic c o n s t r u c t i o n s o r e s t a b l i s h m e n t s t h a t c a n e m i t electromagnetic waves, because signal reception may be affected.
  • Page 25: Using Battery

    Warning and Notice • An operating temperature between 0°C and +40°C and humidity between 5% and 95% are recommended. Using Battery • Do not short-circuit the battery, as this can cause excessive heat and fire. • Do not store battery in hot areas or dispose of it in a fire to avoid explosion.
  • Page 26: Limited Warranty

    End users’ mishandling, misuse, negligence, or improper installation, disassembly, storage, servicing or operation of the product. iv. Modifications or repairs not provided by ZTE or a ZTE-certified individual. Power failures, surges, fire, flood, accidents, and actions of third parties or other events outside ZTE’...
  • Page 27 Any other cause beyond the range of normal usage intended for the product. End users have no right to reject or return the product, or receive a refund for the product from ZTE under the above- mentioned situations. This warranty is end users’ sole remedy and ZTE’s sole...
  • Page 28: Limitation Of Liability

    Warning and Notice Limitation of Liability ZTE shall not be liable for any loss of profits or indirect, special, incidental or consequential damages resulting from or arising out of or in connection with using of this product, no matter whether or not ZTE had been advised, knew or...
  • Page 29: Legal Information

    ZTE Corporation. The manual is published by ZTE Corporation. We reserve the right to make modifications on print errors or update specifications without prior notice. Version No.: R1.0 Edition Time: March 17, 2015 Manual No.:079584507213...
  • Page 30: Troubleshooting

    Troubleshooting Problem Recommended Action • Install the software, and run the The connection installation program in the path of between your My Computer. device and a PC • If the driver of your device is through a USB abnormal, reinstall the software. cable cannot be You need to uninstall the software established.
  • Page 31 Troubleshooting Problem Recommended Action • Ensure that your (U)SIM card is available. The client • Change the location and find a connected to the place with good signal. device cannot • Check the settings of the WAN access the connection mode. Internet.

Table of Contents