Replace The Glide Contacts Of The Suction Turbine; Replacing The Mains Cable - Kärcher NT 35/1 AP Te Service Manual

1 Top seal ring, to the appliance hood
2 Suction turbine
3 Bottom seal ring, to the turbine holder

Replace the suction turbine.

Check the seal rings for damage.

Replace damaged seal rings.

Align the suction turbine inside the turbine holders
by means of the seal rings during installation.
8.8.1 Replace the glide contacts of the suction
turbine.
1 Glide contact (carbon brush)
2 Contact part

Unscrew the screws of the contact part.

Pull the contact part off toward the top, do not
bend the plug contact.

Remove the glide contact and replace it.

Install a new glide contact; no adjustments neces-
sary.

Always replace both glide contacts at once.
16
English 5.906-520.0 Rev. 00 (03/12)

8.9 Replacing the mains cable


Unscrew the fastening screws of the traction relief.

Disconnect the connecting cable of the mains ca-
ble on the appliance electronics and on the appli-
ance switch.

Replace the mains cable.