Table of Contents
Advertisement
Restoring defaults
When in programming mode, you can enter the following sequence...
When the master code is forgotten....
1) Wire a push button (or replicate with wire link) across the Egress terminal and (-)GND.
2) Switch off power for 1 minute.
3) Switch ON power.
4) during the first 60 seconds, press the EG button once to enable the function.
5) Enter the following code..
The keypad should now be in programming mode, ready to accept new data.
Using the standard codes...
Once you have exited out of programming mode, simply enter the user code.
Using super user codes
The handset should be charged for 8 hours before use. It is recommended to give it at least 1
hour charge before range testing.
Ring Another Handset
Press
and the unit will
display HS1-5 depending on
how many handsets are coded.
Press
and
to select and
then OK to call that handset.
Voicemail
When a call is not answered
within 40 seconds, the visitor
can leave a message. Once
complete, the handset will
display the
symbol. The unit
can store up to 16 messages.
P a g e
| 9
Using the keypad
Activate output 1
Activate output 2
Activate output 3
The Handset
Reception
indicator
12.21
ON/OFF
OK
Charging
base
Power
LED
Change Ring Volume
Battery
Press
and
Level
and decrease ring volume
Voicemail
and press OK to save.
Symbol
Change Ring Tone
Vibration
ON/OFF
Press
and the handset will
ring with its currently selected
tone.
Press
and
through available ring tones
and press OK to select and
Code
Button
save.
to increase
to cycle
Advertisement
Table of Contents
