Zennio MAXinBOX FC 0-10V VALVE User Manual page 21

Two/four-pipe fan coil controller with 0-10 vdc valve control signal

Hide thumbs Also See for MAXinBOX FC 0-10V VALVE:

Table of Contents

MAXinBOX FC 0-10V VALVE

Cyclical Monitoring Period: sets every how much time, at most, the alarm

object should be updated from the bus after an initial reception has already

taken place. If exceeded, and for safety reasons, the alarm action will be

triggered as well. If this parameter is set to zero (default option), the cyclical

monitoring function will remain disabled. Permitted values are 0 to 600 tenths

of a second; 0 to 3600 seconds; 0 to 1440 minutes; and 0 to 24 hours.

Valve Position: sets, in terms of percentage, the target opening level of the

valve or valves, depending on whether the module has been configured as a

four-pipe or a two-pipe fan coil (see section 2.5.1).

Fan Speed: sets the target fan speed, depending on how many speeds have

been parameterised (see section 2.5.1).

http://www.zennio.com

Technical Support:

http://zennioenglish.zendesk.com

Table of Contents

Need help?

Do you have a question about the MAXinBOX FC 0-10V VALVE and is the answer not in the manual?