Zennio MAXinBOX FC 0-10V VALVE Manual

2-pipe or 4-pipe fan coil controller with 0-10VDC valve and up to 4 fan speed
ZCL-FC010V
FEATURES
•
2 x 0-10VDC individual outputs for valve control.
•
4 individual outputs (suitable for capacitive loads, maximum 140µF)
capable of controlling up to 4 fan speeds.
•
4 analog/digital inputs.
•
Manual output operation in 0-10VDC and individual outputs with push
button and status indicator LED.
•
Logical functions.
•
Output timing facilities.
•
Total data saving on power failure.
•
DIN rail unit assembly (EN 50022), with snap fit clamp.
•
Size 67 x 90 x 80 mm (4.5 DIN units).
•
KNX BCU integrated
•
Possibility to connect different phases in adjoining outputs.
•
Conformity with the CE directives (CE-mark on the right side).
1. Analog/Digital inputs
5. Programming/Test LED
Programming/test button: short press to set programming mode. If this button is held while plugging the device into the KNX bus, it enters the safe
mode. If this button is held for more than 3 seconds, the device enters the test mode.
Programming/Test LED: programming mode indicator (red). When the device enters the safe mode, it blinks (red) every half second. The manual mode
is indicated by the green color. During the start-up (reset or after KNX bus failure) and if the device is not in safe mode, it starts a blue blinking sequence.
GENERAL SPECIFICATIONS
CONCEPT
Type of device
Voltage (typical)
Voltage range
KNX supply Maximum
consumption
Connection type
External power supply
Operation temperature
Storage temperature
Operation humidity
Storage humidity
Complementary characteristics
Protection class
Operation type
Device action type
Electrical stress period
Degree of protection
Installation
Minimum clearances
Response on KNX bus failure
Response on KNX bus restart
Operation indicator
Weight
PCB CTI index
Housing material
¹ Maximum consumption in the worst case scenario (KNX Fan-In model)
© Zennio Avance y Tecnología S.L.
2. 0-10VDC outputs
6. Lower outputs
Voltage
29VDC (typical)
24VDC¹
Edition 4
MAXinBOX FC 0-10V VALVE
3
4
3. Output status LED indicator
7. KNX connection
DESCRIPTION
Electric operation control device
29VDC SELV
21..31VDC
mA
11
15
Typical TP1 bus connector for 0.80mm Ø rigid cable
Not required
0°C .. +55°C
-20°C .. +55°C
5 .. 95% (No condens.)
5 .. 95% (No condens.)
Class B
II
Continuous operation
Type 1
Long
IP20, clean environment
Independent device to be mounted inside electrical panels with DIN rail (EN
50022)
Not required
Data saving according to parameterization
Data recovery according to parameterization
The programming LED indicates programming mode (red) and test mode
(green). Each output LED indicates its status
248g
175V
PC FR V0 halogen free
Futher information
TECHNICAL DOCUMENTATION
2
5
6
Figure 1: MAXinBOX FC 0-10V VALVE
4. Output control button
8. Programming/Test button
mW
319
360
www.zennio.com
1
8
7
Page 1/2