AudioCodes Mediant 2000 System User Manual page 84

Parameter
Enable Semi-Attended Transfer
[EnableSemiAttendedTransfer]
3xx Behavior
[3xxBehavior]
Enable P-Charging Vector
[EnablePChargingVector]
Enable VoiceMail URI
[EnableVMURI]
SIP User's Manual
Table 5-8: General Parameters (Protocol Definition)
Determines the gateway behavior when Transfer is initiated
while still in Alerting state.
Valid options include:
[0] Disable = Send REFER with Replaces (default).
[1] Enable = Send CANCEL, and after a 487 response is
received, send REFER without Replaces.
Determines the gateway's behavior when a 3xx response is
received for an outgoing INVITE request. The gateway can
either use the same call identifiers (CallID, branch, to and
from tags) or change them in the new initiated INVITE.
[0] Forward = Use different call identifiers for a redirected
INVITE message (default).
[1] Redirect = Use the same call identifiers.
Enables the addition of a P-Charging-Vector header to all
outgoing INVITE messages.
Valid options include:
[0] Disable = Disable (default)
[1] Enable = Enable
Enables or disables the interworking of target and cause for
redirection from Tel to IP and vice versa, according to RFC
4468.
Valid options include:
[0] Disable = Disable (default).
[1] Enable = Enable
Upon receipt of a SETUP request with redirect values, the
gateway maps the Redirect phone number to the target
parameter, and the Redirect number reason to the cause
parameter in the Request-URI.
Redirecting Reason
Unknown
User busy
No reply
Deflection
Unconditional
Others
If the gateway receives a Request-URI that includes a target
and cause parameters, the target is mapped to the redirect
phone number and the cause is mapped to redirect number
reason.
Mediant 2000 & TP-1610 & TP-260/UNI
Description
>> Value
>> 404
>> 486
>> 408
>> 487/480
>> 302
>> 302
84 Document #: LTRT-68806