Assigning An Ip Address Using Bootp; Assigning An Ip Address Using The Cli - AudioCodes Mediant 2000 System User Manual

SIP User's Manual
Tip:
4.3.2

Assigning an IP Address Using BootP

The procedure below describes how to assign the gateway an IP address using the
supplied BootP application. For a detailed description on using AudioCodes' BootP
application, refer to the SIP Series Reference Manual.
Note:
Tip:
To assign an IP address using BootP, take these 3 steps:
Open the BootP application (supplied with the gateway's software package).
1.
Add a client configuration for the gateway that you want to initialize.
2.
Press the gateway's hardware Reset button to physically reset the gateway so that it
3.
uses BootP; the gateway changes its network parameters to the values provided by
the BootP.
Repeat steps 2 through 3 for the gateway's second module (if used).
4.3.3

Assigning an IP Address Using the CLI

Assigning an IP address using the command-line interface (CLI) is performed in two
stages:
Accessing the CLI (refer to 'Accessing the CLI' on page 52) using a standard Telnet
1.
application or serial communication software (e.g., HyperTerminal
RS-232 port (if supported).
Assigning an IP address to the gateway (refer to 'Assigning an IP Address' on page
2.
53).
Version 5.2
Record and retain the IP address and subnet mask you assign the gateway.
Do the same when defining new username or password. If the Embedded
Web Server is unavailable (for example, if you've lost your username and
password), use the BootP/TFTP (Trivial File Transfer Protocol) configuration
utility to access the device, 'reflash' the load and reset the password (refer to
the SIP Series Reference Manual). For detailed information on using a
BootP/TFTP configuration utility to access the device).
BootP procedure can also be performed using any standard compatible
BootP server.
You can also use BootP to load the auxiliary files to the gateway (refer to the
SIP Series Reference Manual).
51
4. Getting Started
) connected to the
TM
September 2007