Table of Contents
Advertisement
4.5 I/O extension connector
The FX
-20GM can connect the following extension block.
2N
1) FX
series extension block
2NC
- FX
-16EX-DS
2NC
- FX
-16EX-T-DS
2NC
- FX
-32EX-D/UL
2NC
2) FX
series extension block (FX
2N
- FX
-16EX-ES/UL
2N
The increase point is 48 points or less. Assume the turning on rate to be 50% or less simultaneously.
48 points may be added to the system if 50% or less are used simultaneously.
lock
FX
-20GM
2N
4.6 Connection with PLC
Refer to the FX
-10GM and the FX
2N
the system configuration.
4.7 Detaching the memory board
7.8k step of RAM is built into the FX
16) can be used. (Program capacity is 7.8k steps)
Installation
4.8 Procedure of battery exchange
1) The power supply of FX
2) Remove side cover from the FX
3) Remove battery from holder-disconnect and replace. (This must be carried out within 30 sec if the cur-
rent data held in the FX
4) Refit battery and cover.
5. Specification
5.1 Power supply specification
Item
Power supply
Allowance power
failure time
Power consumption
Fuse
5.2 General specification
Item
Ambient temperature 0 to 55°C (operation). -20 to 70°C (storage).
Surrounding humidity 35 to 85% (No condensation) ..... operation
Vibration resistance
Shock resistance
- FX
-16EYT-DSS
2NC
- FX
-16EX-D/UL
2NC
- FX
-32EYT-D/UL
2NC
-CNV-IF needs to be used)
2NC
- FX
-16EYT-ESS/UL
2N
lock
Extension block
-20GM HARDWARE PROGRAMMING MANUAL for details concerning
2N
-20GM. In addition, the optional memory board (FX
2N
Removal
-20GM is turned off.
2N
-20GM.
2N
-20GM's RAM is to be saved.)
2N
FX
-32BL
2NC
lithium battery
24V DC +10%, -15%
The operation is continued to the momentary power failure is 5ms or less.
10W
125V 1A
Frequency 10 to 57Hz: Half 0.035mm amplitude,
Frequency 57 to 150Hz: 4.9 m/s
Sweep count for X,Y, Z: 10 times (80 min in each direction).
147m/s
2
acceleration, Action time: 11ms.
3 times in each direction X, Y, Z.
- FX
-32EX-DS
2NC
- FX
-16EYT-D/UL
2NC
1. Detach the extension cover on the right side of
the FX
-20GM.
2N
2. Insert the hooks of the extension blocks into
the lock holes, and gently press the units
together.
3. lower the lock to fix the units in place.
4. Attach other extension blocks in the same
manner.
1)
Turn off the power supply to the FX
20GM.
2)
Remove the cover of the memory board.
3)
Install the memory board in the connec-
tor.
4)
Replace the cover before turning on the
power supply.
5)
When detaching the memory board,
begin by carefully detaching it from the
bottom side.
Contents
Contents
2
Acceleration
- FX
-32EYT-DSS
2NC
2NC
-EEPROM-
-
2N
Advertisement
Table of Contents
