Programming: Sharing Handshake Data - Aiphone GT SERIES Quick Start Installation Manual

PROGRAMMING:
The handshake programming method can be used within a Tenant Section only. The handshake is a correlation
between the tenant and an entrance station or guard station. In order for the Main Section to call a tenant station that
was programmed via handshake in the Tenant Section, the link ID will need to be shared between the entrance/guard
station that was programmed and the Tenant Section MCX.
After completing the handshake process on pages 14-15 for the tenant stations, download the data from the entrance
station or guard station that was programmed for those stations.
Step 1: Click Download
Step 2: From the Download menu, select the LAN radio button. Select the Tenant Section MCX where the
entrance/guard station programmed with handshake data resides. Verify the IP address is correct.
Select the entrance/guard station that was programmed with the handshake data. Click OK . Click Yes
Step 3:
in the popup window asking if it's ok to overwrite the data. Enter the Admin Passcode and click OK . The
default Admin Passcode is *1111.
Step 4: Copy/paste (Ctrl C, Ctrl V) or use Compare and Merge Settings
downloaded resident data from the downloaded entrance/guard station to the Tenant Section MCX and
other entrance/guard stations in this section.
Step 5: After all data has been copy/pasted or Compare and Merged to the MCX and each entrance/guard station
in this section, Upload settings to all stations in this section again (see page 23).
Step 6: Repeat steps 1 - 5 for each tenant section in the system.
24 | GT Series Quick Start Guide
SHARING HANDSHAKE DATA
.
(page 22) to send the newly
http://www.aiphone.net/
Issue Date: Nov. 2017 FK2114
AIPHONE CO., LTD., NAGOYA, JAPAN
B 1117 RZ 60150