HP LaserJet MFP Analog Fax Accessory 300 Fax Manual page 72

Problem
Faxes are transmitting
or being received very
slowly (continued).
Faxes are not printing
on the MFP.
64 Chapter 6 Troubleshooting
Cause
The resolution at which the
fax was sent or is being
received is very high. A
higher resolution typically
results in better quality, but
also requires a longer
transmission time.
If there is a poor phone-line
connection, the fax accessory
and the receiving fax machine
slow down the transmission
to adjust for errors.
There is no media in the
media input tray.
Schedule Printing of Faxes
is set.
The MFP is either low on
toner or has run out of toner.
Solution
If you are receiving the fax, call and
ask the sender to decrease the
resolution and resend the fax.
If you are sending, decrease the
resolution, see "Setting outgoing
fax resolution" on page 38 and
also, change the Page Content
mode setting described under
"To send a fax - enter number(s)
manually" on page 18.
Cancel and resend the fax.
Have the phone company check
the phone line.
Load media. Any faxes received
while the input tray is empty are
stored and will print after the tray
has been refilled.
If Schedule Printing of Faxes is
enabled, faxes will not print until it
is disabled. If you wish to print your
faxes, see "To enable/disable
schedule printing of faxes" on
page 49.
The MFP stops printing as soon as
it is low on toner or runs out of
toner. Any faxes received are
stored in memory and print after
the toner has been replaced. For
other MFP printing problems, see
the MFP user guide.
ENWW